EUVIMEDOntdek EUVIMED
Crossref

THE EFFECT OF CEMENT AND SCREW ON THE RESISTANCE OF AN IMPLANT CROWN TELESCOPICALLY ENGAGED TO A HEXAGONAL-SHAPED ABUTMENT UNDER COMPRESSIVE DYNAMIC CYCLIC FATIGUE LOADING

Jan C Kwan, Norman Kwan

The International Journal of Prosthodontics · 2024

DOI: 10.11607/ijp.8362 ↗

At a glance

Journal article in The International Journal of Prosthodontics, 2024. Written by Jan C Kwan and 1 co-authors. Major MEDLINE topics: Crowns, Dental Abutments, Dental Stress Analysis, Dental Restoration Failure. Cited 1 times so far (Crossref).

SamenvattingSubjectsBibliografische gegevensCiteRelated studies

Abstract (original language)

PURPOSE: To investigate the resistance of an implant crown telescopically engaged to a geometrically defined hexagonal abutment with and without cement under compressive dynamic cyclic fatigue loading. MATERIALS AND METHODS: 40 crowns, 9 mm in height, were cast from prefabricated plastic copings, each telescopically engaged to a 3-mm-high machined hexagonal abutment. 20 crowns were retained with zinc phosphate cement, and 20 crowns were retained with a screw. A vertical load of 15 kg was applied to all samples under oscilla)on. A Periotest was used to measure the mobility of the implant crown in Periotest values (PTV). Test endpoints were defined by the following: fatigue cycles ≥ 20 million; crown PTV > 10; or if samples became visibly loose or component fracture. RESULTS: Cement-retained crowns failed on average at 2.60 x 106 cycles ± 2.27, while screw-retained crown samples failed at 2.17 x 106 cycles ± 1.27 with no significant difference (P > .05). Implant and abutment screw fractures were the most prevalent mode of failure in the cement-retained group, while in the screw-retained group, failures were caused by the loosening of one or both screw joints. The rate of increase in PTV was higher in the screw-retained group than in the cement-retained group. CONCLUSIONS: Under the experimental conditions, an implant crown telescopically engaged vertically to a 3-mm-tall hexagonal abutment, under compressive dynamic cyclic fatigue loading with or without cement, demonstrated no differences in resistance or failure outcomes. A cement-retained implant crown with telescopic engagement to the abutment is more rigid, resulting in more implant and abutment screw fractures than loosening.

Subjects

MeSH terms (MEDLINE)

CrownsDental AbutmentsDental Stress AnalysisDental Restoration FailureDental Implant-Abutment DesignDental CementsMaterials TestingDental Prosthesis, Implant-SupportedCompressive StrengthZinc Phosphate CementHumansDental Prosthesis DesignCementation

Author keywords

Dynamic Cyclic Fatigue LoadingEmergence ProfileImplant CrownScrew vs Cement RetentionSet ScrewTelescopic Engagement

Substances

Dental CementsZinc Phosphate Cement

Cite

APA

Kwan, J. C., & Kwan, N. (2024). THE EFFECT OF CEMENT AND SCREW ON THE RESISTANCE OF AN IMPLANT CROWN TELESCOPICALLY ENGAGED TO A HEXAGONAL-SHAPED ABUTMENT UNDER COMPRESSIVE DYNAMIC CYCLIC FATIGUE LOADING. The International Journal of Prosthodontics. https://doi.org/10.11607/ijp.8362

Vancouver

Kwan JC, Kwan N. THE EFFECT OF CEMENT AND SCREW ON THE RESISTANCE OF AN IMPLANT CROWN TELESCOPICALLY ENGAGED TO A HEXAGONAL-SHAPED ABUTMENT UNDER COMPRESSIVE DYNAMIC CYCLIC FATIGUE LOADING. The International Journal of Prosthodontics. 2024. doi:10.11607/ijp.8362

BibTeX
@article{Kwan2024,
  author = {Kwan, Jan C and Kwan, Norman},
  title = {THE EFFECT OF CEMENT AND SCREW ON THE RESISTANCE OF AN IMPLANT CROWN TELESCOPICALLY ENGAGED TO A HEXAGONAL-SHAPED ABUTMENT UNDER COMPRESSIVE DYNAMIC CYCLIC FATIGUE LOADING},
  journal = {The International Journal of Prosthodontics},
  year = {2024},
  doi = {10.11607/ijp.8362}
}
Start for free →