Laser-Induced Temperature Changes on the Outer Surface of Titanium Dental Implants: An In Vitro Study
The International Journal of Oral & Maxillofacial Implants · 2024
DOI: 10.11607/jomi.10656 ↗Kurz gefasst
Fachartikel in der Zeitschrift The International Journal of Oral & Maxillofacial Implants, 2024. Verfasst von Laurent Marchand und 4 weiteren Autor:innen. Hauptthemen laut MEDLINE: Dental Implants, Titanium, Surface Properties, Lasers, Gas. Die Arbeit wurde bisher 1-mal zitiert (Crossref).
Abstract (Originalsprache)
PURPOSE: To measure the surface temperature distribution after using a CO2 laser to heat titanium dental implants via different power settings, application intervals, and irradiation times. MATERIALS AND METHODS: A total of 10 tissue-level titanium implants (Screw-Line Promote Plus, Camlog; 4.3 × 11 mm) were placed (EpoFix, Struers) and irradiated with a CO2 laser (Denta 2, Lutronic) with a wavelength of 10.6 μm at power levels of 4 watts (Group 1), 6 watts (Group 2), 8 watts (Group 3), and 10 watts (Group 4). A continuous beam mode (setting I) and noncontinuous beam modes with 5-second (setting II) and 10-second (setting III) pause intervals were used. For each setting, a total irradiation time of 50 seconds was used and repeated 10 times. The temperature was measured using external thermocouple (Testo) in contact with the implant surface at the implant shoulder, middle, and apex. A linear regression model was used to analyze the data (P = .05). RESULTS: Setting I demonstrated the most rapid increase in implant surface temperature in all three test sites as well as the greatest total temperature at 50 seconds of irradiation time. The greater the pause interval (settings II and III) during the 50 seconds of irradiation, the lower the rate of temperature increase as well as the total temperature in all three test sites and with all power levels. The average temperature difference between the apex and shoulder site was significant for setting III for all groups, but not for any groups in settings I and II. CONCLUSIONS: Heating the internal aspect of an implant with a CO2 laser produces different temperature distribution profiles depending on the laser power level and the application interval. Laser-beam irradiation leads to a temperature gradient, which is greatest at the implant apex and smallest at the implant shoulder.
Schlagwörter
MeSH-Schlagwörter (MEDLINE)
Substanzen
Zitieren
APA
Marchand, L., Cornish, D., Mojon, P., Sailer, I., & Worni, A. (2024). Laser-Induced Temperature Changes on the Outer Surface of Titanium Dental Implants: An In Vitro Study. The International Journal of Oral & Maxillofacial Implants. https://doi.org/10.11607/jomi.10656
Vancouver
Marchand L, Cornish D, Mojon P, Sailer I, Worni A. Laser-Induced Temperature Changes on the Outer Surface of Titanium Dental Implants: An In Vitro Study. The International Journal of Oral & Maxillofacial Implants. 2024. doi:10.11607/jomi.10656
BibTeX
@article{Marchand2024,
author = {Marchand, Laurent and Cornish, David and Mojon, Philippe and Sailer, Irena and Worni, Andreas},
title = {Laser-Induced Temperature Changes on the Outer Surface of Titanium Dental Implants: An In Vitro Study},
journal = {The International Journal of Oral & Maxillofacial Implants},
year = {2024},
doi = {10.11607/jomi.10656}
}
EUVIMED