EUVIMEDSkopri EUVIMED
Open access · CC BY-NC-ND 4.0

Physicomechanical Properties and Morphological Characterization of Several Universal Resin Composites After Different Aging Procedures

Ersilia González-Alenda iD, Bruno Baracco iD, Jorge Perdigão iD, Daniel Jiménez-Díez iD, Miguel Ángel Garrido iD, Pedro Álvarez-Lloret iD, Laura Ceballos iD, Victoria Fuentes iD

Journal of Esthetic and Restorative Dentistry · 2025-12 · 37 (12) · 2533-2545

DOI: 10.1111/jerd.70010 ↗

At a glance

Journal article in Journal of Esthetic and Restorative Dentistry, published online on 2025-08-06. Written by Ersilia González-Alenda and 7 co-authors. Institution: Nursing and Stomatology Department, IDIBO Research Group, Universidad Rey Juan Carlos, Alcorcón, Madrid, Spain. Major MEDLINE topics: Composite Resins, Dental Materials. Cited 13 times so far (Crossref); 66 references. The full text is freely available (open access, CC BY-NC-ND 4.0).

AstrattSubjectsDettalji biblijografiċiCiteRelated studies

Abstract (original language)

Objectives

To evaluate flexural strength, elastic modulus, microhardness, and microstructure of several universal resin composites before and after artificial aging. In addition, filler characterization, water sorption, solubility, and degree of conversion were analyzed.

Methods

Five universal composites, Essentia Universal (EU), Filtek Universal (FU), G‐ænial A'Chord (GA), Omnichroma (OM), and Tetric Prime (TP) were compared to a conventional composite, Filtek Supreme XTE (FS) used as a control. Flexural strength, elastic modulus, microhardness, and microstructure were analyzed at baseline and after three aging procedures: (1) Immersion in artificial saliva at 37°C for 2 weeks; (2) the same immersion followed by 10,000 thermocycles (5°C–55°C); and (3) the previous procedure with an additional 48‐h storage in 75% ethanol at 37°C. SEM characterization of filler particles, water sorption, solubility, and degree of conversion were also assessed.

Results

FU showed the highest flexural strength and elastic modulus. Thermocycling reduced the flexural strength and elastic modulus of all composites except the elastic modulus of FU. FS was the hardest composite and EU the softest. FU, OM, and TP exhibited lower water sorption than FS. EU, GA, and OM exhibited lower solubility than FS. A similar degree of conversion was found for all universal composites.

Conclusion

Differences in mechanical behavior depended on the resin composite tested and the aging treatment.

Subjects

MeSH terms (MEDLINE)

Composite ResinsDental MaterialsFlexural StrengthElastic ModulusMaterials TestingSolubilityHardnessMicroscopy, Electron, Scanning

Author keywords

degree of conversionelectron microscopyfiller characterizationmechanical propertiesmicrohardnesssolubilitysorptionuniversal composite

Substances

Composite ResinsDental Materials

Authors and institutions

  • Nursing and Stomatology Department, IDIBO Research Group, Universidad Rey Juan Carlos, Alcorcón, Madrid, Spain.
  • Department of Restorative Sciences, Division of Operative Dentistry, University of Minnesota, Minneapolis, Minnesota, USA.
  • Department of Chemical, Energy and Mechanical Technology, Universidad Rey Juan Carlos, Móstoles, Madrid, Spain.
  • Department of Geology, Faculty of Geology, University of Oviedo, Oviedo, Spain.

ORCID profiles: Ersilia González-Alenda, Bruno Baracco, Jorge Perdigão, Daniel Jiménez-Díez, Miguel Ángel Garrido, Pedro Álvarez-Lloret, Laura Ceballos, Victoria Fuentes

Cite

APA

González-Alenda, E., Baracco, B., Perdigão, J., Jiménez-Díez, D., Garrido, M. Á., Álvarez-Lloret, P., Ceballos, L., & Fuentes, V. (2025). Physicomechanical Properties and Morphological Characterization of Several Universal Resin Composites After Different Aging Procedures. Journal of Esthetic and Restorative Dentistry, 37(12), 2533-2545. https://doi.org/10.1111/jerd.70010

Vancouver

González-Alenda E, Baracco B, Perdigão J, Jiménez-Díez D, Garrido MÁ, Álvarez-Lloret P, et al. Physicomechanical Properties and Morphological Characterization of Several Universal Resin Composites After Different Aging Procedures. Journal of Esthetic and Restorative Dentistry. 2025;37(12):2533-2545. doi:10.1111/jerd.70010

BibTeX
@article{GonzlezAlenda2025,
  author = {González-Alenda, Ersilia and Baracco, Bruno and Perdigão, Jorge and Jiménez-Díez, Daniel and Garrido, Miguel Ángel and Álvarez-Lloret, Pedro and Ceballos, Laura and Fuentes, Victoria},
  title = {Physicomechanical Properties and Morphological Characterization of Several Universal Resin Composites After Different Aging Procedures},
  journal = {Journal of Esthetic and Restorative Dentistry},
  year = {2025},
  volume = {37},
  number = {12},
  pages = {2533--2545},
  doi = {10.1111/jerd.70010}
}
Start for free →