Physicomechanical Properties and Morphological Characterization of Several Universal Resin Composites After Different Aging Procedures
Journal of Esthetic and Restorative Dentistry · 2025-12 · 37 (12) · 2533-2545
DOI: 10.1111/jerd.70010 ↗At a glance
Journal article in Journal of Esthetic and Restorative Dentistry, published online on 2025-08-06. Written by Ersilia González-Alenda and 7 co-authors. Institution: Nursing and Stomatology Department, IDIBO Research Group, Universidad Rey Juan Carlos, Alcorcón, Madrid, Spain. Major MEDLINE topics: Composite Resins, Dental Materials. Cited 13 times so far (Crossref); 66 references. The full text is freely available (open access, CC BY-NC-ND 4.0).
Abstract (original language)
Objectives
To evaluate flexural strength, elastic modulus, microhardness, and microstructure of several universal resin composites before and after artificial aging. In addition, filler characterization, water sorption, solubility, and degree of conversion were analyzed.
Methods
Five universal composites, Essentia Universal (EU), Filtek Universal (FU), G‐ænial A'Chord (GA), Omnichroma (OM), and Tetric Prime (TP) were compared to a conventional composite, Filtek Supreme XTE (FS) used as a control. Flexural strength, elastic modulus, microhardness, and microstructure were analyzed at baseline and after three aging procedures: (1) Immersion in artificial saliva at 37°C for 2 weeks; (2) the same immersion followed by 10,000 thermocycles (5°C–55°C); and (3) the previous procedure with an additional 48‐h storage in 75% ethanol at 37°C. SEM characterization of filler particles, water sorption, solubility, and degree of conversion were also assessed.
Results
FU showed the highest flexural strength and elastic modulus. Thermocycling reduced the flexural strength and elastic modulus of all composites except the elastic modulus of FU. FS was the hardest composite and EU the softest. FU, OM, and TP exhibited lower water sorption than FS. EU, GA, and OM exhibited lower solubility than FS. A similar degree of conversion was found for all universal composites.
Conclusion
Differences in mechanical behavior depended on the resin composite tested and the aging treatment.
Subjects
MeSH terms (MEDLINE)
Author keywords
Substances
Authors and institutions
- Nursing and Stomatology Department, IDIBO Research Group, Universidad Rey Juan Carlos, Alcorcón, Madrid, Spain.
- Department of Restorative Sciences, Division of Operative Dentistry, University of Minnesota, Minneapolis, Minnesota, USA.
- Department of Chemical, Energy and Mechanical Technology, Universidad Rey Juan Carlos, Móstoles, Madrid, Spain.
- Department of Geology, Faculty of Geology, University of Oviedo, Oviedo, Spain.
ORCID profiles: Ersilia González-Alenda, Bruno Baracco, Jorge Perdigão, Daniel Jiménez-Díez, Miguel Ángel Garrido, Pedro Álvarez-Lloret, Laura Ceballos, Victoria Fuentes
Cite
APA
González-Alenda, E., Baracco, B., Perdigão, J., Jiménez-Díez, D., Garrido, M. Á., Álvarez-Lloret, P., Ceballos, L., & Fuentes, V. (2025). Physicomechanical Properties and Morphological Characterization of Several Universal Resin Composites After Different Aging Procedures. Journal of Esthetic and Restorative Dentistry, 37(12), 2533-2545. https://doi.org/10.1111/jerd.70010
Vancouver
González-Alenda E, Baracco B, Perdigão J, Jiménez-Díez D, Garrido MÁ, Álvarez-Lloret P, et al. Physicomechanical Properties and Morphological Characterization of Several Universal Resin Composites After Different Aging Procedures. Journal of Esthetic and Restorative Dentistry. 2025;37(12):2533-2545. doi:10.1111/jerd.70010
BibTeX
@article{GonzlezAlenda2025,
author = {González-Alenda, Ersilia and Baracco, Bruno and Perdigão, Jorge and Jiménez-Díez, Daniel and Garrido, Miguel Ángel and Álvarez-Lloret, Pedro and Ceballos, Laura and Fuentes, Victoria},
title = {Physicomechanical Properties and Morphological Characterization of Several Universal Resin Composites After Different Aging Procedures},
journal = {Journal of Esthetic and Restorative Dentistry},
year = {2025},
volume = {37},
number = {12},
pages = {2533--2545},
doi = {10.1111/jerd.70010}
}
EUVIMED