EUVIMEDEUVIMED entdecken
VergleichsstudieOpen Access · CC BY 4.0

Osseointegration of Anodized vs. Sandblasted Implant Surfaces in a Guided Bone Regeneration Acute Dehiscence‐Type Defect: An In Vivo Experimental Mandibular Minipig Model

Shakeel Shahdad iD, Simon Rawlinson, Nahal Razaghi iD, Anuya Patankar, Mital Patel, Mario Roccuzzo iD, Thomas Gill iD

Clinical Oral Implants Research · 2025

DOI: 10.1111/clr.14369 ↗

Kurz gefasst

Vergleichsstudie in der Zeitschrift Clinical Oral Implants Research, 2025. Verfasst von Shakeel Shahdad und 6 weiteren Autor:innen. Beteiligte Einrichtung: Barts and the London School of Medicine and Dentistry, Institute of Dentistry, Queen Mary University of London, London, UK. Hauptthemen laut MEDLINE: Osseointegration, Swine, Miniature, Surface Properties, Dental Implants. Die Arbeit wurde bisher 3-mal zitiert (Crossref) und nennt 59 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Institut Straumann AG, Straumann Group.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Objectives

This controlled preclinical study analyzed the effect of implant surface characteristics on osseointegration and crestal bone formation in a grafted dehiscence defect minipig model. Material and Methods A standardized 3 mm × 3 mm acute‐type buccal dehiscence minipig model grafted with deproteinized bovine bone mineral and covered with a porcine collagen membrane after 2 and 8 weeks of healing was utilized. Crestal bone formation was analyzed histologically and histomorphometrically to compare three implant groups: (1) a novel, commercially available, gradient anodized (NGA) implant, to two custom‐made geometric replicas of implant “1,” (2) a superhydrophilic micro‐rough large‐grit sandblasted and acid‐etched surface, and (3) a relatively hydrophobic micro‐rough large‐grit sandblasted and acid‐etched surface.

Results

At 2 and 8 weeks, there was no difference between the amount and height of newly formed bone (NBH, new bone height; BATA, bone area to total area) for any of the groups ( p > 0.05). First bone‐to‐implant contact (fBIC) and vertical bone creep (VBC) at 2 and 8 weeks were significantly increased for Groups 2 and 3 compared to Group 1 ( p < 0.05). At 8 weeks, osseointegration in the dehiscence (dehiscence bone‐implant‐contact; dBIC) was significantly higher for Groups 2 and 3 compared to Group 1 ( p < 0.05).

Conclusions

The amount of newly formed bone (BATA) and NBH was not influenced by surface type. However, moderately rough surfaces demonstrated significantly superior levels of osseointegration (dBIC) and coronal bone apposition (fBIC) in the dehiscence defect compared to the NGA surface at 2 and 8 weeks. Trial Registration For this type of study, clinical trial registration is not required. This study was conducted at the Biomedical Department of Lund University (Lund, Sweden) and approved by the local Ethics Committee of the University (M‐192‐14)

Schlagwörter

MeSH-Schlagwörter (MEDLINE)

OsseointegrationSwine, MiniatureSurface PropertiesDental ImplantsMandibleAnimalsSwineSurgical Wound DehiscenceBone RegenerationDental Implantation, EndosseousGuided Tissue Regeneration, PeriodontalDisease Models, Animal

Stichwörter der Autor:innen

SLASLActiveTiUltraanodizeddehiscence type defectsguided bone regenerationhydrophillic implant surfaceimplant crestal bone formationimplant surfaceosseointegration

Substanzen

Dental Implants

Autor:innen und Institutionen

  • Barts and the London School of Medicine and Dentistry, Institute of Dentistry, Queen Mary University of London, London, UK.
  • Department of Restorative Dentistry, The Royal London Dental Hospital, Barts Health NHS Trust, London, UK.
  • Private Practice, Torino, Italy.
  • Department of Maxillo-Facial Surgery, University of Torino, Torino, Italy.
  • Department of Periodontics and Oral Medicine, University of Michigan, Ann Arbor, Michigan, USA.

ORCID-Profile: Shakeel Shahdad, Nahal Razaghi, Mario Roccuzzo, Thomas Gill

Förderung

  • Institut Straumann AG
  • Straumann Group

Zitieren

APA

Shahdad, S., Rawlinson, S., Razaghi, N., Patankar, A., Patel, M., Roccuzzo, M., & Gill, T. (2025). Osseointegration of Anodized vs. Sandblasted Implant Surfaces in a Guided Bone Regeneration Acute Dehiscence‐Type Defect: An In Vivo Experimental Mandibular Minipig Model. Clinical Oral Implants Research. https://doi.org/10.1111/clr.14369

Vancouver

Shahdad S, Rawlinson S, Razaghi N, Patankar A, Patel M, Roccuzzo M, et al. Osseointegration of Anodized vs. Sandblasted Implant Surfaces in a Guided Bone Regeneration Acute Dehiscence‐Type Defect: An In Vivo Experimental Mandibular Minipig Model. Clinical Oral Implants Research. 2025. doi:10.1111/clr.14369

BibTeX
@article{Shahdad2025,
  author = {Shahdad, Shakeel and Rawlinson, Simon and Razaghi, Nahal and Patankar, Anuya and Patel, Mital and Roccuzzo, Mario and Gill, Thomas},
  title = {Osseointegration of Anodized vs. Sandblasted Implant Surfaces in a Guided Bone Regeneration Acute Dehiscence‐Type Defect: An In Vivo Experimental Mandibular Minipig Model},
  journal = {Clinical Oral Implants Research},
  year = {2025},
  doi = {10.1111/clr.14369}
}
Kostenlos starten →