Microfluidic device for continuous blood plasma separation from whole blood
Biosensors and Bioelectronics · 2026
DOI: 10.1016/j.bios.2026.118404 ↗Kurz gefasst
Fachartikel in der Zeitschrift Biosensors and Bioelectronics, 2026. Verfasst von Surendran Velmurugan und 4 weiteren Autor:innen. Beteiligte Einrichtung: Research Center for Microtechnology, FHV - Vorarlberg University of Applied Sciences, Austria; Institute for Synthetic Bioarchitectures, University o…. Hauptthemen laut MEDLINE: Erythrocytes, Cell Separation, Plasma, Microfluidic Analytical Techniques. Die Arbeit wurde bisher 4-mal zitiert (Crossref) und nennt 38 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Deutsche Forschungsgemeinschaft, Austrian Science Fund.
Abstract (Originalsprache)
Sample preparation is a critical step in clinical diagnostics, as plasma must be separated from whole blood before analysis. Conventional centrifugation is time-consuming, require bulky equipment, and is unsuitable for point-of-care (POC) applications. Here, we present a simple and low-cost microfluidic device that achieves continuous (uninterrupted flow separation without batch processing) and real-time (immediate flow separation and inline without delays) plasma separation from undiluted whole human blood without external forces. Six channel geometries were evaluated by numerical simulations to investigate the effects of side-channel orientation and channel height on red blood cell (RBC) contamination carryover. The optimized configuration with a 20-μm channel height, minimized recirculation zones and enhanced inertial focusing, leading to reduced RBC contamination in the side channel plasma outlet. Devices were then fabricated by standard photolithography and soft lithography. Experimental validation with whole human blood demonstrated that the device significantly reduced red blood cell (RBC) contamination across a flow rate range of 0.05-0.2 mL min-1, yielding plasma with substantially lower RBC levels compared with whole blood, although low residual RBCs were still present. Flow cytometry further confirmed an efficient depletion of peripheral blood mononuclear cells (PBMCs), resulting in markedly lower leukocyte content than in plasma obtained by standard centrifugation. The plasma yield reached 3.8 %, corresponding to an extraction rate of 6.5 μL min-1, and hemolysis levels remained comparable to centrifuged samples, indicating preservation of plasma integrity. This established device provides a robust platform for high-purity plasma separation and has a strong potential for point-of-care diagnostic applications.
Schlagwörter
MeSH-Schlagwörter (MEDLINE)
Stichwörter der Autor:innen
Autor:innen und Institutionen
- Research Center for Microtechnology, FHV - Vorarlberg University of Applied Sciences, Austria; Institute for Synthetic Bioarchitectures, University of Natural Resources and Life Sciences (BOKU), Austria.
- Department of Thoracic and Cardiovascular Surgery, University Hospital Tübingen, Germany.
- Department of Electrical Engineering - School of Computation, Information and Technology, Technical University of Munich, Germany.
- Research Center for Microtechnology, FHV - Vorarlberg University of Applied Sciences, Austria. Electronic address: stefan.partel@fhv.at.
Förderung
- Deutsche Forschungsgemeinschaft
- Austrian Science Fund
Zitieren
APA
Velmurugan, S., Girbas, M. G., Dincer, C., Avci-Adali, M., & Partel, S. (2026). Microfluidic device for continuous blood plasma separation from whole blood. Biosensors and Bioelectronics. https://doi.org/10.1016/j.bios.2026.118404
Vancouver
Velmurugan S, Girbas MG, Dincer C, Avci-Adali M, Partel S. Microfluidic device for continuous blood plasma separation from whole blood. Biosensors and Bioelectronics. 2026. doi:10.1016/j.bios.2026.118404
BibTeX
@article{Velmurugan2026,
author = {Velmurugan, Surendran and Girbas, Melis Güler and Dincer, Can and Avci-Adali, Meltem and Partel, Stefan},
title = {Microfluidic device for continuous blood plasma separation from whole blood},
journal = {Biosensors and Bioelectronics},
year = {2026},
doi = {10.1016/j.bios.2026.118404}
}
EUVIMED