EUVIMEDScopri EUVIMED
Crossref

Temperature Effect on Bonding Quality of Polyether‐Ether‐Ketone Composites During Injection Over‐Molding

Yufan Yang, Nan Hu, Haiming Liu, Jie Hao, Zijie Wu

Polymer Composites · 2026-11-18

DOI: 10.1002/pc.71837 ↗

At a glance

Journal article in Polymer Composites, published online on 2026-11-18. Written by Yufan Yang and 4 co-authors. 27 references. Funded by: National Natural Science Foundation of China.

AbstractDati bibliograficiCiteRelated studies

Abstract (original language)

This study investigates the effect of temperature during the injection over‐molding (IOM) process on the interfacial bonding quality of prefabricated composite components (hot‐pressed inserts) and short fiber reinforced polyether–ether–ketone (PEEK) injection molding produced composites. The moldflow analysis software is employed to simulate the IOM process interface temperature field, followed by experimental verification of the interface bonding strength through single‐lap shear tests. The main findings indicate that optimizing the injection and mold temperatures can increase the joint strength by more than two and five times, respectively. The injection temperature of 410°C promotes resin intermingling, thereby improving the bond quality, while a mold temperature of around 200°C decreases the rate of cooling, thereby extending the resin intermingling and crystallization window, which in turn improves the joint strength. This paper substantiates the feasibility of the IOM process for PEEK composites and offers new insights into joint assembly methods within the composites industry.

Funding

  • National Natural Science Foundation of China

Cite

APA

Yang, Y., Hu, N., Liu, H., Hao, J., & Wu, Z. (2026). Temperature Effect on Bonding Quality of Polyether‐Ether‐Ketone Composites During Injection Over‐Molding. Polymer Composites. https://doi.org/10.1002/pc.71837

Vancouver

Yang Y, Hu N, Liu H, Hao J, Wu Z. Temperature Effect on Bonding Quality of Polyether‐Ether‐Ketone Composites During Injection Over‐Molding. Polymer Composites. 2026. doi:10.1002/pc.71837

BibTeX
@article{Yang2026,
  author = {Yang, Yufan and Hu, Nan and Liu, Haiming and Hao, Jie and Wu, Zijie},
  title = {Temperature Effect on Bonding Quality of Polyether‐Ether‐Ketone Composites During Injection Over‐Molding},
  journal = {Polymer Composites},
  year = {2026},
  doi = {10.1002/pc.71837}
}
Start for free →