The Effect of the Deposition Strategy and Heat Treatment on Cold Spray Additive Manufactured 316L Stainless Steel
Advanced Engineering Materials · 2024-07 · 26 (14)
DOI: 10.1002/adem.202302156 ↗Kurz gefasst
Fachartikel in der Zeitschrift Advanced Engineering Materials, online erschienen am 25.04.2024. Verfasst von Rodolpho F. Vaz und 7 weiteren Autor:innen. Die Arbeit wurde bisher 37-mal zitiert (Crossref) und nennt 60 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC 4.0). Gefördert von: Ministerio de Ciencia e Innovación, Coordenação de Aperfeiçoamento de Pessoal de Nível Superior.
Abstract (Originalsprache)
Herein, the effect of heat treatment on the characteristics and properties of cold spray additive manufactured 316L stainless steel employing traditional and a new metal knitting strategy is investigated. 316L feedstock powder characteristics, the geometry of the bulk, microstructure, porosity, microhardness, mechanical isotropy, and residual stress are analyzed in both strategies in as‐sprayed and heat‐treated conditions. Results show that the traditional deposition strategy produced higher mechanical resistance, whereas metal knitting presents a better part geometry accuracy. The heat treatment significantly improves the material strength and the quality of the parts by recovery and recrystallization phenomena. The same microhardness and planar isotropy are achieved after heat treatment of samples produced by both strategies. A discussion about the mechanisms, microstructural, and residual stress evolution is presented.
Förderung
- Ministerio de Ciencia e Innovación
- Coordenação de Aperfeiçoamento de Pessoal de Nível Superior
Zitieren
APA
Vaz, R. F., Luzin, V., Salvemini, F., Ribamar, G. G., Ávila, J. A., Albaladejo, V., Sanchez, J., & Cano, I. G. (2024). The Effect of the Deposition Strategy and Heat Treatment on Cold Spray Additive Manufactured 316L Stainless Steel. Advanced Engineering Materials, 26(14). https://doi.org/10.1002/adem.202302156
Vancouver
Vaz RF, Luzin V, Salvemini F, Ribamar GG, Ávila JA, Albaladejo V, et al. The Effect of the Deposition Strategy and Heat Treatment on Cold Spray Additive Manufactured 316L Stainless Steel. Advanced Engineering Materials. 2024;26(14). doi:10.1002/adem.202302156
BibTeX
@article{Vaz2024,
author = {Vaz, Rodolpho F. and Luzin, Vladimir and Salvemini, Filomena and Ribamar, Giovani G. and Ávila, Julian A. and Albaladejo, Vicente and Sanchez, Javier and Cano, Irene Garcia},
title = {The Effect of the Deposition Strategy and Heat Treatment on Cold Spray Additive Manufactured 316L Stainless Steel},
journal = {Advanced Engineering Materials},
year = {2024},
volume = {26},
number = {14},
doi = {10.1002/adem.202302156}
}
EUVIMED