EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Fatigue Response of Additive-Manufactured 316L Stainless Steel

Melody Chepkoech, Peter Omoniyi, Gbadebo Owolabi

Metals · 29.08.2024 · 14 (9) · 988

DOI: 10.3390/met14090988 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Metals, online erschienen am 29.08.2024. Verfasst von Melody Chepkoech und 2 weiteren Autor:innen. Die Arbeit wurde bisher 10-mal zitiert (Crossref) und nennt 46 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Department of Energy—National Nuclear Security Administration (DOE-NNSA), Department of Defence.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This study investigated the fatigue performance of 316L stainless steel fabricated via laser powder bed fusion (LPBF). Stress-controlled fatigue tests were performed at different stress amplitudes on vertically built samples using a frequency of 15 Hz and a stress ratio of 0.1. The stress amplitudes were varied to provide the cyclic response of the materials under a range of loading conditions. The average fatigue strength was determined to be 92.94 MPa, corresponding to a maximum stress of 185.87 MPa. The microstructures were observed through scanning electron microscopy (SEM) with the aid of electron backscattered diffraction (EBSD), and the average grain size of the as-built samples was determined to be 15.6 µm, with most grains having a preferred crystallographic orientation. A higher kernel average misorientation value was measured on the deformed surfaces, revealing the increased misorientation of the grains. Defects were observed on the fractured surfaces acting as crack initiators while deflecting the crack propagation paths. The fatigue failure mode for the LPBF 316L samples was ductile, as illustrated by the numerous dimples on fracture surfaces and fatigue striations.

Förderung

  • Department of Energy—National Nuclear Security Administration (DOE-NNSA)
  • Department of Defence

Zitieren

APA

Chepkoech, M., Omoniyi, P., & Owolabi, G. (2024). Fatigue Response of Additive-Manufactured 316L Stainless Steel. Metals, 14(9), 988. https://doi.org/10.3390/met14090988

Vancouver

Chepkoech M, Omoniyi P, Owolabi G. Fatigue Response of Additive-Manufactured 316L Stainless Steel. Metals. 2024;14(9):988. doi:10.3390/met14090988

BibTeX
@article{Chepkoech2024,
  author = {Chepkoech, Melody and Omoniyi, Peter and Owolabi, Gbadebo},
  title = {Fatigue Response of Additive-Manufactured 316L Stainless Steel},
  journal = {Metals},
  year = {2024},
  volume = {14},
  number = {9},
  pages = {988},
  doi = {10.3390/met14090988}
}
Kostenlos starten →