Effect of Light-Curing Tip Distance on the Top and Bottom Surface Microhardness of Two Single-Shade Resin Composites: An In Vitro Study
Journal of Health and Biology · 2026
DOI: 10.71428/jhb.2026.0210 ↗Kurz gefasst
Fachartikel in der Zeitschrift Journal of Health and Biology, 2026. Verfasst von Ghadeer Shabaa.
Abstract (Originalsprache)
Aim
The purpose of this in vitro experiment was to measure the difference in surface microhardness and bottom-to-top hardness ratio between two single-shade resin composites as a function of increasing light-curing tip distance. Materials and Methods: We used Palfique OMNICHROMA and ONEshade Universal to create sixty disk-shaped specimens (n = 30 for each). Using the light-curing tip distance as a criterion, we separated each material into three subgroups (n = 10). After being polymerized for 30 seconds at 1000 mW/cm² in an LED curing machine, the specimens were immersed in distilled water and left to cure at 37°C for 24 hours. We determined the bottom-to-top hardness ratio by measuring the Vickers microhardness on both the top and bottom surfaces. We used three-way mixed ANOVA and two-way ANOVA to analyze the data, with a significance level of α = 0.05.
Results
Both composites showed a significant decrease in microhardness as the curing distance increased (p < 0.001). At all curing distances, ONEshade showed considerably stronger top and bottom microhardness compared to OMNICHROMA (p < 0.001). Hardness ratios measured from bottom to top fell somewhere between 83.96% and 90.07%, with no group falling below the 80% mark.
Conclusion
Both single-shade composite microhardness decreased as the light-curing tip distance increased, but the relative polymerization remained sufficient at a specimen thickness of 2 mm. To get the most out of single-shade resin composites mechanically, you should keep the curing-tip distance to a minimum.
Zitieren
APA
Shabaa, G. (2026). Effect of Light-Curing Tip Distance on the Top and Bottom Surface Microhardness of Two Single-Shade Resin Composites: An In Vitro Study. Journal of Health and Biology. https://doi.org/10.71428/jhb.2026.0210
Vancouver
Shabaa G. Effect of Light-Curing Tip Distance on the Top and Bottom Surface Microhardness of Two Single-Shade Resin Composites: An In Vitro Study. Journal of Health and Biology. 2026. doi:10.71428/jhb.2026.0210
BibTeX
@article{Shabaa2026,
author = {Shabaa, Ghadeer},
title = {Effect of Light-Curing Tip Distance on the Top and Bottom Surface Microhardness of Two Single-Shade Resin Composites: An In Vitro Study},
journal = {Journal of Health and Biology},
year = {2026},
doi = {10.71428/jhb.2026.0210}
}
EUVIMED