EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Investigate the effect of various cutting parameters on the surface roughness of aluminum alloy 5052 by using Taguchi method

Asmail Alfrjani Alshanta, Saleh A. Almajdup, Mohamed Etuhami Swei

Al-Farooq Journal of Sciences · 21.11.2026 · 2 (4) · 1606-1617

DOI: 10.65405/2yvdct20 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Al-Farooq Journal of Sciences, online erschienen am 21.11.2026. Verfasst von Asmail Alfrjani Alshanta und 2 weiteren Autor:innen. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The characteristic surface finish of machining is a key indicator of product quality and an indispensable customer requirement. Taguchi robust parameter design for optimizing surface finish in the turning of 5052 AL alloy using carbide cutting has been utilized in this paper. Using the Taguchi method for AA5052 aluminum alloy machining reveals that feed rate, cutting speed, and depth of cut significantly impact surface roughness, with feed rate often being the dominant factor, followed by speed, then depth. The results showed that lower feed rates (e.g., 0.1 mm/rev) and higher cutting speeds (e.g., 900 rpm) generally yield the best (lowest) surface roughness (Ra), while optimal depth of cut varies but often favors lower values. ANOVA and Signal-to-Noise (S/N) ratio analyses confirm parameter significance, allowing prediction of optimal settings for improved quality. Finally, we developed the relationship between cutting parameters and response using MINITAB-16 and performed regression analysis. The predicted values were compared with the experimental values, and it was observed that both values were very close; hence, the models prepared were more accurate and adequate.

Zitieren

APA

Alshanta, A. A., Almajdup, S. A., & Swei, M. E. (2026). Investigate the effect of various cutting parameters on the surface roughness of aluminum alloy 5052 by using Taguchi method. Al-Farooq Journal of Sciences, 2(4), 1606-1617. https://doi.org/10.65405/2yvdct20

Vancouver

Alshanta AA, Almajdup SA, Swei ME. Investigate the effect of various cutting parameters on the surface roughness of aluminum alloy 5052 by using Taguchi method. Al-Farooq Journal of Sciences. 2026;2(4):1606-1617. doi:10.65405/2yvdct20

BibTeX
@article{Alshanta2026,
  author = {Alshanta, Asmail Alfrjani and Almajdup, Saleh A. and Swei, Mohamed Etuhami},
  title = {Investigate the effect of various cutting parameters on the surface roughness of aluminum alloy 5052 by using Taguchi method},
  journal = {Al-Farooq Journal of Sciences},
  year = {2026},
  volume = {2},
  number = {4},
  pages = {1606--1617},
  doi = {10.65405/2yvdct20}
}
Kostenlos starten →