EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Investigation of Cutting Parameters Effect's on Surface Roughness ‎and Tool Wear in CNC Milling of Aluminum Alloy 6061‎

Omar Ahmed Murshid

Journal of University of Babylon for Engineering Sciences · 31.03.2026 · 34 (1) · 155-174

DOI: 10.29196/jubes.v34i1.6474 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of University of Babylon for Engineering Sciences, online erschienen am 31.03.2026. Verfasst von Omar Ahmed Murshid. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This comprehensive investigation systematically examines the machinability characteristics of Aluminum Alloy 6061-T6 through precision CNC end milling on a 3-axis Vertical Machining Center (VMC). Experiments employed a High-Speed Steel (HSS) 5-flute end mill cutter ( 10 mm diameter) under flood coolant conditions (15 L/min flow rate, 1:20 water-soluble oil emulsion) to ensure thermal stability and effective chip evacuation. A Taguchi orthogonal array enabled efficient parametric analysis of three key variables: spindle speed (1000, 2000, 3000 rpm), feed rate (100, 200, 300 mm/min), and axial depth of cut (0.5, 1.0, 1.5 mm). Analysis of Variance (ANOVA) reveals that feed rate dominantly influences arithmetic surface roughness (74.8% contribution, , ), while spindle speed primarily governs tool flank wear (60.1% variance contribution). A novel "chip crowding" phenomenon emerges at Material Removal Rates (MRR) >3000 mm³/min, where the 5-flute geometry's restricted flute gullet capacity induces chip re-cutting and catastrophic surface deterioration (+260% degradation). Developed multiple linear regression models demonstrate high predictive fidelity ( for , 92.8% for flank wear), validated by confirmation runs (e.g., Run 7: predicted 0.52 µm vs. measured 0.55 µm, 5.5% error). The optimal combination (3000 rpm, 100 mm/min, 0.5 mm depth) yields a 69% reduction, establishing an industry benchmark for Al6061-T6 finish machining.

Zitieren

APA

Murshid, O. A. (2026). Investigation of Cutting Parameters Effect's on Surface Roughness ‎and Tool Wear in CNC Milling of Aluminum Alloy 6061‎. Journal of University of Babylon for Engineering Sciences, 34(1), 155-174. https://doi.org/10.29196/jubes.v34i1.6474

Vancouver

Murshid OA. Investigation of Cutting Parameters Effect's on Surface Roughness ‎and Tool Wear in CNC Milling of Aluminum Alloy 6061‎. Journal of University of Babylon for Engineering Sciences. 2026;34(1):155-174. doi:10.29196/jubes.v34i1.6474

BibTeX
@article{Murshid2026,
  author = {Murshid, Omar Ahmed},
  title = {Investigation of Cutting Parameters Effect's on Surface Roughness ‎and Tool Wear in CNC Milling of Aluminum Alloy 6061‎},
  journal = {Journal of University of Babylon for Engineering Sciences},
  year = {2026},
  volume = {34},
  number = {1},
  pages = {155--174},
  doi = {10.29196/jubes.v34i1.6474}
}
Kostenlos starten →