EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Exploring how 3D printing parameters affect the flexural strength of ABS materials

Diki Anggara, Rifelino Rifelino, Zainal Abadi, Andril Arafat

Innovation in Engineering · 30.09.2024 · 1 (2) · 125-133

DOI: 10.58712/ie.v1i2.16 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Innovation in Engineering, online erschienen am 30.09.2024. Verfasst von Diki Anggara und 3 weiteren Autor:innen. Die Arbeit wurde bisher 1-mal zitiert (Crossref). Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

: This research focuses on testing the flexural strength of Acrylonitrile Butadiene Styrene (ABS) materials used in 3D printing by the Fused Deposition Modeling (FDM) method. The objective of this study was to evaluate the mechanical strength of ABS using a full factorial experimental design, applying three main factors such as layer height, infill density and infill pattern. Flexural testing was conducted following ASTM D790 standards. A total of 27 specimens were made by varying the layer height, infill density and infill pattern. The results showed that layer height was the most influential factor on flexural strength, with the highest value of 41.815 Mpa at 0.2 mm layer height, 100% infill density, and line infill pattern. ANOVA analysis supported this conclusion with p values

Zitieren

APA

Anggara, D., Rifelino, R., Abadi, Z., & Arafat, A. (2024). Exploring how 3D printing parameters affect the flexural strength of ABS materials. Innovation in Engineering, 1(2), 125-133. https://doi.org/10.58712/ie.v1i2.16

Vancouver

Anggara D, Rifelino R, Abadi Z, Arafat A. Exploring how 3D printing parameters affect the flexural strength of ABS materials. Innovation in Engineering. 2024;1(2):125-133. doi:10.58712/ie.v1i2.16

BibTeX
@article{Anggara2024,
  author = {Anggara, Diki and Rifelino, Rifelino and Abadi, Zainal and Arafat, Andril},
  title = {Exploring how 3D printing parameters affect the flexural strength of ABS materials},
  journal = {Innovation in Engineering},
  year = {2024},
  volume = {1},
  number = {2},
  pages = {125--133},
  doi = {10.58712/ie.v1i2.16}
}
Kostenlos starten →