EUVIMEDEUVIMED entdecken
Crossref

A Constitutive Model for Carbon Nanotube and Carbon Black Reinforced Rubber Nanocomposite Sensors Applied to Structural Health Monitoring

Eduardo Preto, José Malmonge, Rafael Teloli, Gaël Chevallier, Samuel da Silva

e-Journal of Nondestructive Testing · 2026-08 · 31 (8)

DOI: 10.58286/33703 ↗

Kurz gefasst

Fachartikel in der Zeitschrift e-Journal of Nondestructive Testing, 2026-08. Verfasst von Eduardo Preto und 4 weiteren Autor:innen.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Piezoresistive nanocomposites have emerged as a promising alternative for structural monitoring, combining low sensor cost, simple fabrication and analysis, and real-time measurement capability. Despite advances in developing new nanocomposites and their experimental applications, there remains a gap in studies addressing the mathematical modeling of their electromechanical behavior. This work presents the development of a constitutive model for a piezoresistive nanocomposite composed of a natural rubber matrix reinforced with carbon nanotubes (CNT) and carbon black (CB), which has previously been employed to detect tightening loss in bolted joints with promising results. The sensor has a washer-shaped geometry and is installed between the bolt washer and the bolted joint interface, so that the deformation generated in the joint alters the electrical response of the sensor. Samples with different nanofiller proportions were fabricated and characterized to extract their piezoresistive properties. Mechanical stress and electrical conductivity under cyclic deformation were approximated by linear relationships whose coefficients varied with nanofiller concentration. Subsequently, a nonlinear formulation was proposed to describe the combined influence of CNT and CB on these coefficients. The model was calibrated using Bayesian inference, enabling the estimation of both conductivity and mechanical stress under various deformation conditions. The proposed constitutive model can be integrated into multiphysics simulation software, enabling virtual testing of the sensor within complex structures and optimizing its characteristics for different applications. The agreement between simulated and experimental results confirms the model’s capability to simulate and tune the sensitivity of nanocomposite sensors by adjusting CNT and CB contents, facilitating the design of customized real-time structural monitoring sensors for specific bolted joint configurations.

Zitieren

APA

Preto, E., Malmonge, J., Teloli, R., Chevallier, G., & Silva, S. D. (2026). A Constitutive Model for Carbon Nanotube and Carbon Black Reinforced Rubber Nanocomposite Sensors Applied to Structural Health Monitoring. e-Journal of Nondestructive Testing, 31(8). https://doi.org/10.58286/33703

Vancouver

Preto E, Malmonge J, Teloli R, Chevallier G, Silva SD. A Constitutive Model for Carbon Nanotube and Carbon Black Reinforced Rubber Nanocomposite Sensors Applied to Structural Health Monitoring. e-Journal of Nondestructive Testing. 2026;31(8). doi:10.58286/33703

BibTeX
@article{Preto2026,
  author = {Preto, Eduardo and Malmonge, José and Teloli, Rafael and Chevallier, Gaël and Silva, Samuel da},
  title = {A Constitutive Model for Carbon Nanotube and Carbon Black Reinforced Rubber Nanocomposite Sensors Applied to Structural Health Monitoring},
  journal = {e-Journal of Nondestructive Testing},
  year = {2026},
  volume = {31},
  number = {8},
  doi = {10.58286/33703}
}
Kostenlos starten →