EUVIMEDEUVIMED entdecken
Crossref

Comparison of Strength, Surface Quality and Cost of Different Additive Manufacturing Methods

Mehmet Mahir SOFU, Hatice VAROL ÖZKAVAK, Selim BACAK, Mehmet FENKLİ

İmalat Teknolojileri ve Uygulamaları · 2023

DOI: 10.52795/mateca.1265509 ↗

Kurz gefasst

Fachartikel in der Zeitschrift İmalat Teknolojileri ve Uygulamaları, 2023. Verfasst von Mehmet Mahir SOFU und 3 weiteren Autor:innen. Die Arbeit nennt 28 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Additive manufacturing is a manufacturing method that includes systems that produce using many different methods. The most widely used and accessible methods of additive manufacturing can be listed as Fused Deposition Modeling (FDM), Selective Laser Sintering (SLS) and UV light assisted Stereolithography (SLA). Today, it is quite easy to produce thermoplastic products suitable for direct use in low quantities with these three methods. In addition, the production success of the parts produced in geometric difficulties also increases this demand. The most important problem is the lack of sufficient studies and information about the strength limits, surface quality and costs of the parts produced for additive manufacturing methods with such advantages. In this study, the comparison of three different production methods in terms of surface roughness, strength and cost is discussed in order to eliminate this deficiency in the literature. For this purpose, the tensile strength and surface roughness values of the samples produced using FDM, SLS and SLA methods were determined. In addition, cost analyzes were made depending on the production time of the produced samples. In the study, the lowest cost was obtained in the SLA material with a value of $ 0.19. Again, the lowest values were obtained for the samples produced from SLA material, with a production time of 17 minutes and a surface roughness of 1.96µm compared to other methods. However, when evaluated in terms of strength, the highest strength value was obtained as 57.67 N/mm2 in the FDM method.

Zitieren

APA

SOFU, M. M., ÖZKAVAK, H. V., BACAK, S., & FENKLİ, M. (2023). Comparison of Strength, Surface Quality and Cost of Different Additive Manufacturing Methods. İmalat Teknolojileri ve Uygulamaları. https://doi.org/10.52795/mateca.1265509

Vancouver

SOFU MM, ÖZKAVAK HV, BACAK S, FENKLİ M. Comparison of Strength, Surface Quality and Cost of Different Additive Manufacturing Methods. İmalat Teknolojileri ve Uygulamaları. 2023. doi:10.52795/mateca.1265509

BibTeX
@article{SOFU2023,
  author = {SOFU, Mehmet Mahir and ÖZKAVAK, Hatice VAROL and BACAK, Selim and FENKLİ, Mehmet},
  title = {Comparison of Strength, Surface Quality and Cost of Different Additive Manufacturing Methods},
  journal = {İmalat Teknolojileri ve Uygulamaları},
  year = {2023},
  doi = {10.52795/mateca.1265509}
}
Kostenlos starten →