EUVIMEDEUVIMED entdecken
Crossref

Additive Manufacturing Methods for Embedded Resistors

Gregory Tighe, John Bennett, Guinevere Strack, Alkim Akyurtlu, Andrea BoeroVera, Mahsa Ghandi, Jasmina Burek

IMAPSource Proceedings · 26.10.2026 · 2026 (Symposium)

DOI: 10.4071/001c.173030 ↗

Kurz gefasst

Fachartikel in der Zeitschrift IMAPSource Proceedings, online erschienen am 26.10.2026. Verfasst von Gregory Tighe und 6 weiteren Autor:innen.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Embedded resistors can reduce component count, routing complexity, and assembly requirements in high density printed circuit boards (PCBs); however, conventional subtractive manufacturing of patterned resistive foils requires multiple steps and generates large amounts of hazardous waste and CO2 emissions. In this work, we investigate direct-write additive manufacturing of resistive films onto patterned copper terminations as a potential replacement for lithographically patterned foil resistors. Carbon-based resistive inks were deposited using a Voltera Nova dispensing platform and characterized to determine the effects of substrate fixturing, deposited geometry, process calibration, and copper–resistor interface resistance. Substrate fixturing was identified as a critical source of variability because the contact-based surface probing routine can deform thin PCB substrates and produce an inaccurate height map. Direct measurements on substrates confirmed that vacuum-bed fixturing limited out-of-plane displacement to 0.01 mm to 0.02 mm while corner clamping produced deformation of 0.72 mm. Replacing clamping with vacuum-bed fixturing reduced the maximum resistance variation from 150% to 6%. Variable length resistance calibration coupons were used to determine copper termination spacings for target values for 25, 50 and 100 Ω resistors. Results demonstrate batch resistance tolerances within ±5%, successfully remaining within the 20% tolerance threshold for foil resistors. Resistance vs. length measurements also indicated an apparent interface resistance contribution of approximately 4–8 Ω. Passivation of the copper surface with a layer of gold supported the hypothesis that the interface chemistry contributes to device resistance; however, the interface contribution is not sufficiently stable over time to be treated as a fixed calibration parameter. Preliminary life-cycle assessment indicated that the printed resistor approach can reduce panel-level CO2 emissions relative to conventional NiCr embedded resistor foil technologies. The results demonstrate that substrate planarity, surface height measurement, and interface control are key requirements for repeatable direct-write fabrication of printed embedded resistors.

Zitieren

APA

Tighe, G., Bennett, J., Strack, G., Akyurtlu, A., BoeroVera, A., Ghandi, M., & Burek, J. (2026). Additive Manufacturing Methods for Embedded Resistors. IMAPSource Proceedings, 2026(Symposium). https://doi.org/10.4071/001c.173030

Vancouver

Tighe G, Bennett J, Strack G, Akyurtlu A, BoeroVera A, Ghandi M, et al. Additive Manufacturing Methods for Embedded Resistors. IMAPSource Proceedings. 2026;2026(Symposium). doi:10.4071/001c.173030

BibTeX
@article{Tighe2026,
  author = {Tighe, Gregory and Bennett, John and Strack, Guinevere and Akyurtlu, Alkim and BoeroVera, Andrea and Ghandi, Mahsa and Burek, Jasmina},
  title = {Additive Manufacturing Methods for Embedded Resistors},
  journal = {IMAPSource Proceedings},
  year = {2026},
  volume = {2026},
  number = {Symposium},
  doi = {10.4071/001c.173030}
}
Kostenlos starten →