Multimaterial Hybrid Additive Manufacturing of Smart Polymer Structures with Embedded Electronics
ACS Applied Electronic Materials · 12.11.2026
DOI: 10.1021/acsaelm.6c01769 ↗Kurz gefasst
Fachartikel in der Zeitschrift ACS Applied Electronic Materials, online erschienen am 12.11.2026. Verfasst von Jaehun Jeon und 8 weiteren Autor:innen. Die Arbeit nennt 45 Literaturangaben. Gefördert von: Rensselaer Polytechnic Institute, Center for Smart Convergent Manufacturing Systems, NYSTAR Support.
Abstract (Originalsprache)
Additive manufacturing (AM) provides a promising route for integrating electronic functionalities into polymer structures. However, existing approaches often rely on strong chemicals, post-processing, or assembly steps that limit design flexibility, manufacturing efficiency, and electrical reliability. This study presents a multimaterial hybrid AM strategy that integrates fused filament fabrication with cold spray additive manufacturing (CSAM) to fabricate polymer structures with embedded functionality. Tin (Sn) electrodes were directly deposited onto 3D-printed polymer substrates via CSAM and subsequently encapsulated through polymer over-printing, eliminating the need for surface pretreatment, thermal sintering, chemical metallization, or adhesive bonding. A systematic design of experiments with microstructural characterization established the process–structure–property relationships governing polymer metallization, identifying the optimal processing conditions for producing continuous conductive pathways with an electrical conductivity of 3.76 × 105 S·m–1. The versatility of the proposed approach was demonstrated through three representative fully embedded smart structures: (i) a strain sensor with a gauge factor of 2.766; (ii) a triboelectric nanogenerator (TENG) capable of generating a peak output voltage of ∼65 V and a peak power density of 3 μW cm–2; and (iii) a radio-frequency identification (RFID) circuit. These results provide a pathway toward smart polymer electronics (plastronics) for next-generation engineering systems.
Förderung
- Rensselaer Polytechnic Institute
- Center for Smart Convergent Manufacturing Systems
- NYSTAR Support
Zitieren
APA
Jeon, J., Abir, S. S. H., Huang, S., Dhar, J., Richard, G., Ananda, A. R., Kopsaftopoulos, F., Samuel, J., & Akin, S. (2026). Multimaterial Hybrid Additive Manufacturing of Smart Polymer Structures with Embedded Electronics. ACS Applied Electronic Materials. https://doi.org/10.1021/acsaelm.6c01769
Vancouver
Jeon J, Abir SSH, Huang S, Dhar J, Richard G, Ananda AR, et al. Multimaterial Hybrid Additive Manufacturing of Smart Polymer Structures with Embedded Electronics. ACS Applied Electronic Materials. 2026. doi:10.1021/acsaelm.6c01769
BibTeX
@article{Jeon2026,
author = {Jeon, Jaehun and Abir, SK Shamim Hasan and Huang, Shinan and Dhar, Joni and Richard, Grace and Ananda, Akshay R. and Kopsaftopoulos, Fotis and Samuel, Johnson and Akin, Semih},
title = {Multimaterial Hybrid Additive Manufacturing of Smart Polymer Structures with Embedded Electronics},
journal = {ACS Applied Electronic Materials},
year = {2026},
doi = {10.1021/acsaelm.6c01769}
}
EUVIMED