EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Microstructure Modification of Hot Formed Shafts through Customised Spray Cooling from the Forming Heat

Matthias Hammes, Armin Piwek, Norman Mohnfeld, Julius Peddinghaus, Johanna Uhe, Bernd Arno Behrens

Materials Science Forum · 13.04.2026 · 1183 · 13-23

DOI: 10.4028/p-lda6yf ↗

Kurz gefasst

Fachartikel in der Zeitschrift Materials Science Forum, online erschienen am 13.04.2026. Verfasst von Matthias Hammes und 5 weiteren Autor:innen. Die Arbeit nennt 18 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

In order to achieve a long service life for highly stressed parts such as shafts for drivetrains, a combination of a bainitic microstructure with compressive surface residual stresses is beneficial. While a bainitic microstructure offers a good balance between strength and toughness, compressive residual stresses especially near the surface have a positive impact on service life. Research has shown that this is due to a shift of the crack initiation towards the core and a reduced crack growth . These properties can be achieved by hot forming as an established method for manufacturing highly stressed parts followed by an adapted cooling strategy. As this general approach was demonstrated for a simplified process in a prior study , the present article is dedicated to the functionalisation for hot forming processes. In detail, a customised spray cooling is presented for a hot impact extrusion process whereby shafts made of AISI 4140 are cooled down from the forming heat in a single step with adjusted cooling rates. In a finite element-based process design, different cooling strategies were investigated and adequate heat treatments to achieve the combined properties were identified. Following this process design, shafts are formed via hot impact extrusion and spray cooled according to the cooling strategy for experimental validation of the numerical model. Additionally, shafts with air cooling are produced as a reference. During forming, force-displacement curves are measured, which are used for the validation of the numerical hot impact extrusion simulation. The resulting plastic strain and temperature distribution significantly influence the following cooling simulation. The final microstructure as well as hardness values of the produced shafts are determined and compared for the varying cooling strategies.

Zitieren

APA

Hammes, M., Piwek, A., Mohnfeld, N., Peddinghaus, J., Uhe, J., & Behrens, B. A. (2026). Microstructure Modification of Hot Formed Shafts through Customised Spray Cooling from the Forming Heat. Materials Science Forum, 1183, 13-23. https://doi.org/10.4028/p-lda6yf

Vancouver

Hammes M, Piwek A, Mohnfeld N, Peddinghaus J, Uhe J, Behrens BA. Microstructure Modification of Hot Formed Shafts through Customised Spray Cooling from the Forming Heat. Materials Science Forum. 2026;1183:13-23. doi:10.4028/p-lda6yf

BibTeX
@article{Hammes2026,
  author = {Hammes, Matthias and Piwek, Armin and Mohnfeld, Norman and Peddinghaus, Julius and Uhe, Johanna and Behrens, Bernd Arno},
  title = {Microstructure Modification of Hot Formed Shafts through Customised Spray Cooling from the Forming Heat},
  journal = {Materials Science Forum},
  year = {2026},
  volume = {1183},
  pages = {13--23},
  doi = {10.4028/p-lda6yf}
}
Kostenlos starten →