EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Democratising Engineering Education: Fabrication and Experimental Validation of a Low-Cost FDM 3D-Printed Metal-Composite Plate Heat Exchanger

Héctor De Paz Carmona, Rubén Díaz López, Óscar García-Afonso

International Journal of Engineering Pedagogy (iJEP) · 15.05.2026 · 16 (3)

DOI: 10.3991/ijep.v16i3.60829 ↗

Kurz gefasst

Fachartikel in der Zeitschrift International Journal of Engineering Pedagogy (iJEP), online erschienen am 15.05.2026. Verfasst von Héctor De Paz Carmona und 2 weiteren Autor:innen. Die Arbeit nennt 40 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Heat exchange is a key part of the current chemical and mechanical engineering curriculums at the university. However, students often see it as abstract because of the ‘black box’ nature of commercial heat exchangers in industry and the high cost of laboratory pilot plants for learning. This manuscript introduces an innovative educational project focused on the design, 3D-printing, and experimental testing of a plate heat exchanger (PHE). To overcome the low thermal conductivity of standard PLA for FDM printing, a high-metal-composite filament (>60% bronze-filled) was used, which allowed for much more efficient heat exchange. The project, conducted by a chemical engineering undergraduate student, consisted of an initial screening of open-source 3D models of heat exchangers, followed by fused deposition modelling 3D printing using different filaments and technical validation. The experimental testing was performed using tap water at 60ºC and 20ºC to determine the overall heat transfer coefficient. Our results indicate that 3D-printed PHEs show a significant thermal performance, providing a low-cost alternative to commercial units or expensive learning units. To the best of authors’ knowledge, this approach goes beyond technology. This offers a practical way to update and democratize engineering laboratories while increasing student engagement through hands-on challenges.

Zitieren

APA

Carmona, H. D. P., López, R. D., & García-Afonso, Ó. (2026). Democratising Engineering Education: Fabrication and Experimental Validation of a Low-Cost FDM 3D-Printed Metal-Composite Plate Heat Exchanger. International Journal of Engineering Pedagogy (iJEP), 16(3). https://doi.org/10.3991/ijep.v16i3.60829

Vancouver

Carmona HDP, López RD, García-Afonso Ó. Democratising Engineering Education: Fabrication and Experimental Validation of a Low-Cost FDM 3D-Printed Metal-Composite Plate Heat Exchanger. International Journal of Engineering Pedagogy (iJEP). 2026;16(3). doi:10.3991/ijep.v16i3.60829

BibTeX
@article{Carmona2026,
  author = {Carmona, Héctor De Paz and López, Rubén Díaz and García-Afonso, Óscar},
  title = {Democratising Engineering Education: Fabrication and Experimental Validation of a Low-Cost FDM 3D-Printed Metal-Composite Plate Heat Exchanger},
  journal = {International Journal of Engineering Pedagogy (iJEP)},
  year = {2026},
  volume = {16},
  number = {3},
  doi = {10.3991/ijep.v16i3.60829}
}
Kostenlos starten →