EUVIMEDEUVIMED entdecken
FallberichtOpen Access · CC BY 4.0

Implementing 3D printing in alveolar ridge augmentation procedure – a case report

Krikor Giragosyan iD, Lyubomir Chenchev iD, Vasilena Ivanova iD

Folia Medica · 31.10.2024 · 66 (5) · 721-725

DOI: 10.3897/folmed.66.e123762 ↗

Kurz gefasst

Fallbericht in der Zeitschrift Folia Medica, online erschienen am 31.10.2024. Verfasst von Krikor Giragosyan und 2 weiteren Autor:innen. Beteiligte Einrichtung: Medical University of Plovdiv, Plovdiv, Bulgaria. Hauptthemen laut MEDLINE: Alveolar Ridge Augmentation, Printing, Three-Dimensional. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 7 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Reduction of the bone dimensions after tooth loss leads to complications during dental implant placement and prosthetic rehabilitation of the patient. Ridge augmentation procedures aim to increase the available bone volume and provide adequate surface area for the following treatment. Different methods and materials are suggested for the purposes of guided bone regeneration. This case report represents the management of a severe bone atrophy with a 3D printed titanium mesh.

Schlagwörter

MeSH-Schlagwörter (MEDLINE)

Alveolar Ridge AugmentationPrinting, Three-DimensionalHumansTitaniumMaleSurgical MeshFemaleAlveolar Bone Loss

Stichwörter der Autor:innen

3D printing bone graft ridge augmentation titanium mesh

Substanzen

Titanium

Autor:innen und Institutionen

  • Medical University of Plovdiv, Plovdiv, Bulgaria.

ORCID-Profile: Krikor Giragosyan, Lyubomir Chenchev, Vasilena Ivanova

Zitieren

APA

Giragosyan, K., Chenchev, L., & Ivanova, V. (2024). Implementing 3D printing in alveolar ridge augmentation procedure – a case report. Folia Medica, 66(5), 721-725. https://doi.org/10.3897/folmed.66.e123762

Vancouver

Giragosyan K, Chenchev L, Ivanova V. Implementing 3D printing in alveolar ridge augmentation procedure – a case report. Folia Medica. 2024;66(5):721-725. doi:10.3897/folmed.66.e123762

BibTeX
@article{Giragosyan2024,
  author = {Giragosyan, Krikor and Chenchev, Lyubomir and Ivanova, Vasilena},
  title = {Implementing 3D printing in alveolar ridge augmentation procedure – a case report},
  journal = {Folia Medica},
  year = {2024},
  volume = {66},
  number = {5},
  pages = {721--725},
  doi = {10.3897/folmed.66.e123762}
}
Kostenlos starten →