EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Investigation of Tensile and Impact Properties of 3D-Printed Parts with Varying Nozzle Diameters and Infill Densities

Md. Shahporan Rimon, Sajal Chandra Banik

SciEn Conference Series: Engineering · 02.08.2026 · 4 · 184-189

DOI: 10.38032/scse.2026.4.100 ↗

Kurz gefasst

Fachartikel in der Zeitschrift SciEn Conference Series: Engineering, online erschienen am 02.08.2026. Verfasst von Md. Shahporan Rimon und 1 weiteren Autor:innen. Die Arbeit nennt 12 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This study investigates the effects of nozzle diameter and infill density on the mechanical behavior of PLA+ parts, focusing on tensile and impact properties. I used a Bambu Lab A1 3D printer to manufacture the specimens at infill densities of 50% and 100%, with all other printing parameters fixed. The influence of nozzle diameter on structural integrity and load-bearing capacity was tested at four sizes: 0.2 mm, 0.4 mm, 0.6 mm, and 0.8 mm. The study’s results show that tensile properties and impact energy are highly correlated to both nozzle diameter and infill density. The larger the nozzle diameter, the higher the tensile stress and impact energy. Consistently enhancing the mechanical strength of a material is the increasing infill density of the polymer part. Based on the results, we can obtain some valuable insight into setting the FDM printing parameters that achieve a balance in accuracy, strength and toughness of the PLA+ parts for engineering and practical applications.

Zitieren

APA

Rimon, M. S., & Banik, S. C. (2026). Investigation of Tensile and Impact Properties of 3D-Printed Parts with Varying Nozzle Diameters and Infill Densities. SciEn Conference Series: Engineering, 4, 184-189. https://doi.org/10.38032/scse.2026.4.100

Vancouver

Rimon MS, Banik SC. Investigation of Tensile and Impact Properties of 3D-Printed Parts with Varying Nozzle Diameters and Infill Densities. SciEn Conference Series: Engineering. 2026;4:184-189. doi:10.38032/scse.2026.4.100

BibTeX
@article{Rimon2026,
  author = {Rimon, Md. Shahporan and Banik, Sajal Chandra},
  title = {Investigation of Tensile and Impact Properties of 3D-Printed Parts with Varying Nozzle Diameters and Infill Densities},
  journal = {SciEn Conference Series: Engineering},
  year = {2026},
  volume = {4},
  pages = {184--189},
  doi = {10.38032/scse.2026.4.100}
}
Kostenlos starten →