EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

The Influence of Infill Density on the Impact Behavior of 3D‐Printed PLA Parts

Mihai Costea, Miruna Ciolcă, Bogdan‐Nicolae Stoian

Macromolecular Symposia · 2026-08 · 415 (4)

DOI: 10.1002/masy.70407 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Macromolecular Symposia, online erschienen am 02.07.2026. Verfasst von Mihai Costea und 2 weiteren Autor:innen. Die Arbeit nennt 20 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The study focuses on the experimental determination of the impact behavior of PLA components manufactured through additive manufacturing, where the infill density of each tested specimen is varied. The evaluation of the impact energy absorbed by each configuration provides relevant insights into the influence of internal structure on mechanical performance, thus contributing to the optimization of manufacturing parameters for the development of components that must respect the efficiency in terms of mechanical strength and material use. In this paper, the authors investigate the influence of internal structure on impact strength by proposing four different infill density configurations for 3D‐printed PLA specimens: 30%, 50%, 80%, and 100% infill. These variations were selected to provide a comprehensive understanding of how internal material volume increase affects the mechanical performances under impact loading. By systematically analyzing the absorbed impact energy for each configuration, the study aims to establish correlations between infill percentage and structural integrity, offering valuable insights for optimizing additive manufacturing parameters.

Zitieren

APA

Costea, M., Ciolcă, M., & Stoian, B. (2026). The Influence of Infill Density on the Impact Behavior of 3D‐Printed PLA Parts. Macromolecular Symposia, 415(4). https://doi.org/10.1002/masy.70407

Vancouver

Costea M, Ciolcă M, Stoian B. The Influence of Infill Density on the Impact Behavior of 3D‐Printed PLA Parts. Macromolecular Symposia. 2026;415(4). doi:10.1002/masy.70407

BibTeX
@article{Costea2026,
  author = {Costea, Mihai and Ciolcă, Miruna and Stoian, Bogdan‐Nicolae},
  title = {The Influence of Infill Density on the Impact Behavior of 3D‐Printed PLA Parts},
  journal = {Macromolecular Symposia},
  year = {2026},
  volume = {415},
  number = {4},
  doi = {10.1002/masy.70407}
}
Kostenlos starten →