EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Web Stiffening of Additive Manufactured Polylactide (PLA) Railroad Tracks Using Fiberglass Wrapping

Navanit Sri Shanmugam, Vidya Subhash Chavan, David Boyajian, Shen-En Chen, Nicole L. Braxtan, R. Janardhanam

Digital Manufacturing Technology · 2023

DOI: 10.37256/dmt.3220233190 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Digital Manufacturing Technology, 2023. Verfasst von Navanit Sri Shanmugam und 5 weiteren Autor:innen. Die Arbeit wurde bisher 1-mal zitiert (Crossref). Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Three-dimensional (3D) printed railroad tracks can properly address the rendering of a variety of topographic profiles of naturally occurring landscapes and reduce construction costs. Load tests of PLA railroad tracks found that web failure is a dominant failure mode. This paper evaluates the web stiffening strategies of additively fabricated PLA railroad tracks for rail-guided, micro-people movers (MPMs). To strengthen the track web, web-widening with additional PLA material and stiffening using composite reinforcement using glass fiber reinforced polymer (GFRP) wrap have been investigated. The composite wrapping technique was conducted by bonding fiberglass cloth to both sides of the web using a polymeric resin. Flexural load tests were conducted on the specimens with different infill volume percentages. A linear trend was observed on the peak bending capacities of specimens with PLA infill fiber contents ranging between 20% to 100%. Different failure modes were observed for the different percentage specimens during the tests. When compared to their unreinforced counterparts, the 60% infill specimen had the largest increase in strength about 1,500 N in bending with the addition of GFRP wrap. The tangent stiffnesses of all samples were calculated which showed the 100% infill specimen had the highest increase of approximately 50%. The wrapping reinforcement was found to significantly modify the failure mechanisms of the 3D-printed tracks with different infill volume percentages. The strengthening of the 3D-printed tracks using GFRP wrapping is also shown to be similar to the widening of web sections of the additively printed railroad tracks.

Zitieren

APA

Shanmugam, N. S., Chavan, V. S., Boyajian, D., Chen, S., Braxtan, N. L., & Janardhanam, R. (2023). Web Stiffening of Additive Manufactured Polylactide (PLA) Railroad Tracks Using Fiberglass Wrapping. Digital Manufacturing Technology. https://doi.org/10.37256/dmt.3220233190

Vancouver

Shanmugam NS, Chavan VS, Boyajian D, Chen S, Braxtan NL, Janardhanam R. Web Stiffening of Additive Manufactured Polylactide (PLA) Railroad Tracks Using Fiberglass Wrapping. Digital Manufacturing Technology. 2023. doi:10.37256/dmt.3220233190

BibTeX
@article{Shanmugam2023,
  author = {Shanmugam, Navanit Sri and Chavan, Vidya Subhash and Boyajian, David and Chen, Shen-En and Braxtan, Nicole L. and Janardhanam, R.},
  title = {Web Stiffening of Additive Manufactured Polylactide (PLA) Railroad Tracks Using Fiberglass Wrapping},
  journal = {Digital Manufacturing Technology},
  year = {2023},
  doi = {10.37256/dmt.3220233190}
}
Kostenlos starten →