Effect of electroshock treatment on microstructure evolution of Ti-6Al-4V/Cu-Cr-Zr interface fabricated by laser melting deposition
Engineering Science in Additive Manufacturing · 2025
DOI: 10.36922/esam025430030 ↗Kurz gefasst
Fachartikel in der Zeitschrift Engineering Science in Additive Manufacturing, 2025. Verfasst von Shiqiang Xie und 5 weiteren Autor:innen.
Abstract (Originalsprache)
This study aims to examine the effect of electroshock treatment (EST) on Ti-6Al-4V/Cu-Cr-Zr manufactured by laser melting deposition and explore the microstructure and mechanical properties to investigate the microstructure evolution of copper-based rail composite materials under high-energy-density currents. The results indicated that EST could promote atomic diffusion, enabling rapid preferential growth of TiCu in the metallurgical bonding zone. An increase of the current density promoted the nucleation of the primary Ti2Cu phase induced by the thermal effect of EST, which led to Cu solute enrichment and composition undercooling. Moreover, EST significantly improved nucleation rate and grain boundary migration. The average β grain size of the EST-1 sample increased from 2.83 μm to 3.62 μm, approximately, while the typical basic texture of EST-1 was enhanced. In EST-1, the shear strength of Ti-6Al-4V/Cu-Cr-Zr was 132 MPa, which was 65% higher than that of the original Ti-6Al-4V/Cu-Cr-Zr composite. The improvement in shear strength can be attributed to intergranular nano-precipitation and the improved wettability of Ti-6Al-4V/Cu-Cr-Zr. This work provides valuable insights into the preparation of high-value, high-performance Cu-based composites.
Zitieren
APA
Xie, S., Huang, C., Gong, J., Wang, P., Wen, Y., & Xie, L. (2025). Effect of electroshock treatment on microstructure evolution of Ti-6Al-4V/Cu-Cr-Zr interface fabricated by laser melting deposition. Engineering Science in Additive Manufacturing. https://doi.org/10.36922/esam025430030
Vancouver
Xie S, Huang C, Gong J, Wang P, Wen Y, Xie L. Effect of electroshock treatment on microstructure evolution of Ti-6Al-4V/Cu-Cr-Zr interface fabricated by laser melting deposition. Engineering Science in Additive Manufacturing. 2025. doi:10.36922/esam025430030
BibTeX
@article{Xie2025,
author = {Xie, Shiqiang and Huang, Changlin and Gong, Jiawei and Wang, Pei and Wen, Yan and Xie, Lechun},
title = {Effect of electroshock treatment on microstructure evolution of Ti-6Al-4V/Cu-Cr-Zr interface fabricated by laser melting deposition},
journal = {Engineering Science in Additive Manufacturing},
year = {2025},
doi = {10.36922/esam025430030}
}
EUVIMED