EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Effect of Cutting Parameters and Coolant on High-Speed Steel Tool Wear During Turning of ST37 Steel

Enok Mardiah, Imam Hidayah

Jurnal Teknik Mesin Mechanical Xplore · 31.07.2026 · 7 (1) · 15-29

DOI: 10.36805/gatq8n62 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Jurnal Teknik Mesin Mechanical Xplore, online erschienen am 31.07.2026. Verfasst von Enok Mardiah und 1 weiteren Autor:innen. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Turning is a machining process whose performance is strongly influenced by cutting parameters and coolant application. Inappropriate parameter selection can increase tool wear, deteriorate surface roughness, and reduce machining efficiency. This study aimed to analyze the effects of cutting parameters and coolant use on high-speed steel (HSS) tool wear and surface roughness during the turning of ST37 steel and to determine the optimum parameter combination using the Taguchi method. An experimental approach was employed using a Taguchi L9 (3⁴) orthogonal array with four factors: spindle speed, feed rate, cutting depth, and coolant type, each at three levels. The response variables were flank wear (VB) and surface roughness (Ra) of the workpiece. The data were analyzed using signal-to-noise (S/N) ratio, analysis of variance (ANOVA), multiple linear regression, percentage contribution, and confirmation tests. The results indicate that each cutting parameter has a different influence on tool wear and surface roughness. ANOVA showed that cutting depth was the most influential factor affecting tool wear (49.36%), whereas spindle speed was the dominant factor affecting surface roughness (43.47%). The optimum parameter combination for minimizing tool wear was obtained at a spindle speed of 540 rpm, feed rate of 0.157 mm/min, cutting depth of 0.5 mm, and without coolant. The optimization model was validated using confirmation tests, as the experimental results were within a 95% confidence interval. Overall, the findings demonstrate that selecting appropriate cutting parameters has a greater effect on improving tool life and surface quality than coolants

Zitieren

APA

Mardiah, E., & Hidayah, I. (2026). Effect of Cutting Parameters and Coolant on High-Speed Steel Tool Wear During Turning of ST37 Steel. Jurnal Teknik Mesin Mechanical Xplore, 7(1), 15-29. https://doi.org/10.36805/gatq8n62

Vancouver

Mardiah E, Hidayah I. Effect of Cutting Parameters and Coolant on High-Speed Steel Tool Wear During Turning of ST37 Steel. Jurnal Teknik Mesin Mechanical Xplore. 2026;7(1):15-29. doi:10.36805/gatq8n62

BibTeX
@article{Mardiah2026,
  author = {Mardiah, Enok and Hidayah, Imam},
  title = {Effect of Cutting Parameters and Coolant on High-Speed Steel Tool Wear During Turning of ST37 Steel},
  journal = {Jurnal Teknik Mesin Mechanical Xplore},
  year = {2026},
  volume = {7},
  number = {1},
  pages = {15--29},
  doi = {10.36805/gatq8n62}
}
Kostenlos starten →