EUVIMEDEUVIMED entdecken
Crossref

Impact of Printing Parameters and Post-Curing on Surface Quality in mSLA 3D Printing

Mehmet Albaşkara

Black Sea Journal of Engineering and Science · 15.03.2026 · 9 (2) · 845-853

DOI: 10.34248/bsengineering.1842733 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Black Sea Journal of Engineering and Science, online erschienen am 15.03.2026. Verfasst von Mehmet Albaşkara. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 24 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This study experimentally investigates the effects of printing parameters and post-curing on the surface roughness of photopolymer-based parts produced using the masked stereolithography (mSLA) method. Parameters such as layer thickness (0.02–0.04 mm), exposure time (3–5 s), and printing angle (0–45°) were determined using an L9 Taguchi orthogonal design, and both as-printed and post-cured samples were produced for each combination. Surface roughness was measured in areal (Sa) format using an optical profilometer, and the data were evaluated using analysis of variance (ANOVA) and SN ratios. The findings showed that surface roughness was mostly affected by layer thickness, followed by printing angle, while exposure time had a limited effect. The lowest Sa value was obtained with a layer thickness of 0.02 mm, an exposure time of 3 s, and a printing angle of 0°. Post-curing reduced surface roughness by 8–11% in all groups. However, the magnitude of this improvement depends on the initial surface irregularity. Consequently, it has been demonstrated that both printing and curing parameters should be optimized in applications requiring high surface quality.

Zitieren

APA

Albaşkara, M. (2026). Impact of Printing Parameters and Post-Curing on Surface Quality in mSLA 3D Printing. Black Sea Journal of Engineering and Science, 9(2), 845-853. https://doi.org/10.34248/bsengineering.1842733

Vancouver

Albaşkara M. Impact of Printing Parameters and Post-Curing on Surface Quality in mSLA 3D Printing. Black Sea Journal of Engineering and Science. 2026;9(2):845-853. doi:10.34248/bsengineering.1842733

BibTeX
@article{Albakara2026,
  author = {Albaşkara, Mehmet},
  title = {Impact of Printing Parameters and Post-Curing on Surface Quality in mSLA 3D Printing},
  journal = {Black Sea Journal of Engineering and Science},
  year = {2026},
  volume = {9},
  number = {2},
  pages = {845--853},
  doi = {10.34248/bsengineering.1842733}
}
Kostenlos starten →