EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Influence of the Material Mechanical Properties on Cutting Surface Quality during Turning

Il-Seok Kang, Tae-Ho Lee

Processes · 07.06.2024 · 12 (6) · 1171

DOI: 10.3390/pr12061171 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Processes, online erschienen am 07.06.2024. Verfasst von Il-Seok Kang und 1 weiteren Autor:innen. Die Arbeit wurde bisher 3-mal zitiert (Crossref) und nennt 26 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

In cutting processing, the mechanical properties of the material are very important, and the optimal cutting conditions, depending on strength, hardness, and elongation, affect the quality of the machined surface. Therefore, this study was conducted to obtain optimized cutting conditions such as the tool depth of the cut, cutting speed, and feed rate, considering the mechanical properties of the material. AISI 1045 cold-drawn (CD) bars showed an average tensile strength of 695.31 MPa in the tensile test and an average value of 308.6 HV in the Vickers hardness measurement. AISI 1020 CD bars showed a 22.66% lower average tensile strength of 537.74 MPa and an average of 198.77 HV in the hardness measurement. Therefore, AISI 1020 showed a 32.62% higher elongation than AISI 1045. In the measurement results for surface roughness after cutting, different results were observed depending on the strength and elongation at a feed rate of 0.05 mm/rev. AISI 1045 exhibited the highest machining quality, with a surface roughness of approximately 0.374 µm at a cutting speed of 150 m/min, and the cutting depth was 0.4 mm at a feed rate of 0.05 mm/rev. Alternatively, AISI 1020, which had relatively low strength and hardness with high elongation, exhibited the highest machining quality with a roughness of 0.383 µm with similar cutting parameters as AISI 1045.

Zitieren

APA

Kang, I., & Lee, T. (2024). Influence of the Material Mechanical Properties on Cutting Surface Quality during Turning. Processes, 12(6), 1171. https://doi.org/10.3390/pr12061171

Vancouver

Kang I, Lee T. Influence of the Material Mechanical Properties on Cutting Surface Quality during Turning. Processes. 2024;12(6):1171. doi:10.3390/pr12061171

BibTeX
@article{Kang2024,
  author = {Kang, Il-Seok and Lee, Tae-Ho},
  title = {Influence of the Material Mechanical Properties on Cutting Surface Quality during Turning},
  journal = {Processes},
  year = {2024},
  volume = {12},
  number = {6},
  pages = {1171},
  doi = {10.3390/pr12061171}
}
Kostenlos starten →