EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

On the Influence of Binder Material in PCBN Cutting Tools for Turning Operations of Inconel 718

Francisco Matos, Tiago E. F. Silva, Vitor F. C. Sousa, Francisco Marques, Daniel Figueiredo, Francisco J. G. Silva, Abílio M. P. de Jesus

Metals · 11.05.2023 · 13 (5) · 934

DOI: 10.3390/met13050934 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Metals, online erschienen am 11.05.2023. Verfasst von Francisco Matos und 6 weiteren Autor:innen. Die Arbeit wurde bisher 10-mal zitiert (Crossref) und nennt 43 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Project Hi-rEV—Recuperação do Setor de Componentes Automóveis, Plano de Recuperação e Resiliência (PRR), República Portuguesa.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Inconel 718 is a highly valued material in the aerospace and nuclear industries due to the fact of its exceptional properties. However, the processing of this material is quite difficult, especially through machining processes. Machining this material results in rapid tool wear, even when low material removal rates are considered. In this study, instrumented turning experiments were employed to evaluate the machinability of Inconel 718 alloy using PCBN tools while assessing the usage of two distinct binder phases, TiN and TiC, for those cutting tools. It was found that the tool life was highly sensitive to the cutting speeds but also affected by the workpiece mechanical properties. At lower cutting speeds, notch wear significantly impacted the tool integrity, whereas at higher cutting speeds, flank wear was the primary failure mode of the tool. The flank wear of the tools with TiN-based binder outperformed TiC by almost 30%, presenting a more consistent behavior when machining.

Förderung

  • Project Hi-rEV—Recuperação do Setor de Componentes Automóveis
  • Plano de Recuperação e Resiliência (PRR)
  • República Portuguesa

Zitieren

APA

Matos, F., Silva, T. E. F., Sousa, V. F. C., Marques, F., Figueiredo, D., Silva, F. J. G., & Jesus, A. M. P. D. (2023). On the Influence of Binder Material in PCBN Cutting Tools for Turning Operations of Inconel 718. Metals, 13(5), 934. https://doi.org/10.3390/met13050934

Vancouver

Matos F, Silva TEF, Sousa VFC, Marques F, Figueiredo D, Silva FJG, et al. On the Influence of Binder Material in PCBN Cutting Tools for Turning Operations of Inconel 718. Metals. 2023;13(5):934. doi:10.3390/met13050934

BibTeX
@article{Matos2023,
  author = {Matos, Francisco and Silva, Tiago E. F. and Sousa, Vitor F. C. and Marques, Francisco and Figueiredo, Daniel and Silva, Francisco J. G. and Jesus, Abílio M. P. de},
  title = {On the Influence of Binder Material in PCBN Cutting Tools for Turning Operations of Inconel 718},
  journal = {Metals},
  year = {2023},
  volume = {13},
  number = {5},
  pages = {934},
  doi = {10.3390/met13050934}
}
Kostenlos starten →