EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Impact of Suberin Depolymerization Conditions on the Thermal Properties and Flammability of Rigid Polyurethane Foams

Aiga Ivdre iD, Mikelis Kirpluks iD, Daniela Godina, Arnis Abolins, Laima Vevere iD, Rudolfs Berzins iD, Maris Lauberts iD, Janis Rizikovs iD

Polymers · 29.05.2026 · 18 (11) · 1355

DOI: 10.3390/polym18111355 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Polymers, online erschienen am 29.05.2026. Verfasst von Aiga Ivdre und 7 weiteren Autor:innen. Beteiligte Einrichtung: Latvian State Institute of Wood Chemistry, LV-1006 Riga, Latvia. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 53 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Latvian State Institute of Wood Chemistry.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Suberinic acids (SA) derived from birch outer bark are renewable feedstocks for bio-based polyols suitable for rigid polyurethane (PU) foams. Three SA fractions were prepared under different depolymerization conditions: acidification at pH 1 (SA1), pH 5 (SA2), and FeCl3-assisted treatment (SA3), and their chemical composition was analysed by GC–MS, Py–GC/MS, and GPC–RID. Polyols derived from tall oil fatty acids (TOFA) or epoxidized TOFA with trimethylolpropane were used as the sole polyol components in foam formulations. The SA fractions differed in molecular weight distribution, affecting polyol processability. All foams exhibited similar limiting oxygen index (19–20) and cone calorimetry results, showing no statistically significant differences in flammability. This indicates that variations in depolymerization conditions, including polyphenolic content and removal of higher-molecular-weight fractions during FeCl3 treatment, do not dominate fire performance under the studied conditions. SA3-based polyols showed the lowest viscosity and produced foams with optimal mechanical and thermal properties, while SA1 offered higher yield with comparable performance. These results demonstrate the feasibility of converting SA fractions into functional polyols for rigid PU foams and highlight the FeCl3-treated SA3 fraction and SA1 as the most promising candidates for further development.

Schlagwörter

Stichwörter der Autor:innen

flammabilitypolyolsrigid polyurethane foamssuberinsuberinic acids

Autor:innen und Institutionen

  • Latvian State Institute of Wood Chemistry, LV-1006 Riga, Latvia.

ORCID-Profile: Aiga Ivdre, Mikelis Kirpluks, Laima Vevere, Rudolfs Berzins, Maris Lauberts, Janis Rizikovs

Förderung

  • Latvian State Institute of Wood Chemistry

Zitieren

APA

Ivdre, A., Kirpluks, M., Godina, D., Abolins, A., Vevere, L., Berzins, R., Lauberts, M., & Rizikovs, J. (2026). Impact of Suberin Depolymerization Conditions on the Thermal Properties and Flammability of Rigid Polyurethane Foams. Polymers, 18(11), 1355. https://doi.org/10.3390/polym18111355

Vancouver

Ivdre A, Kirpluks M, Godina D, Abolins A, Vevere L, Berzins R, et al. Impact of Suberin Depolymerization Conditions on the Thermal Properties and Flammability of Rigid Polyurethane Foams. Polymers. 2026;18(11):1355. doi:10.3390/polym18111355

BibTeX
@article{Ivdre2026,
  author = {Ivdre, Aiga and Kirpluks, Mikelis and Godina, Daniela and Abolins, Arnis and Vevere, Laima and Berzins, Rudolfs and Lauberts, Maris and Rizikovs, Janis},
  title = {Impact of Suberin Depolymerization Conditions on the Thermal Properties and Flammability of Rigid Polyurethane Foams},
  journal = {Polymers},
  year = {2026},
  volume = {18},
  number = {11},
  pages = {1355},
  doi = {10.3390/polym18111355}
}
Kostenlos starten →