Phase Composition of Al–Si Alloys for Internal Combustion Engine Pistons: Finite Element Structural Analysis
Metals · 14.03.2026 · 16 (3) · 325
DOI: 10.3390/met16030325 ↗Kurz gefasst
Fachartikel in der Zeitschrift Metals, online erschienen am 14.03.2026. Verfasst von Atanasi Tashev und 4 weiteren Autor:innen. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 51 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: European Regional Development Fund.
Abstract (Originalsprache)
The structural reliability of pistons operating under severe thermo-mechanical loading strongly depends on the properties of the selected Al–Si alloy. This study presents an integrated experimental–numerical investigation of hypereutectic Al–Si alloys intended for piston applications. Phase constitution and silicon morphology were characterized by metallography and X-ray diffraction, while tensile testing provided mechanical properties for finite element modeling. The experimentally determined parameters were implemented in a three-dimensional piston model to evaluate stress distribution, deformation, and safety margins under maximum combustion pressure and maximum engine speed. The simulations revealed maximum von Mises stresses up to 150 MPa, with inter-alloy differences below 0.3%, indicating geometry-dominated stress behavior. The maximum displacement did not exceed 76 µm, varying by approximately 3% between alloys. In contrast, the minimum factor of safety ranged from 1.20 to 1.35, showing differences of up to 12%, primarily governed by yield strength and microstructural homogeneity. The results demonstrate that piston performance under combustion-dominated loading is strength-controlled rather than stiffness-controlled. The study provides quantitative insight into the structure–properties–performance relationship of hypereutectic Al–Si alloys and supports informed material selection for preliminary piston design.
Förderung
- European Regional Development Fund
Zitieren
APA
Tashev, A., Dimova, D., Dochev, B., Solakov, T., & Trojan, K. (2026). Phase Composition of Al–Si Alloys for Internal Combustion Engine Pistons: Finite Element Structural Analysis. Metals, 16(3), 325. https://doi.org/10.3390/met16030325
Vancouver
Tashev A, Dimova D, Dochev B, Solakov T, Trojan K. Phase Composition of Al–Si Alloys for Internal Combustion Engine Pistons: Finite Element Structural Analysis. Metals. 2026;16(3):325. doi:10.3390/met16030325
BibTeX
@article{Tashev2026,
author = {Tashev, Atanasi and Dimova, Desislava and Dochev, Boyan and Solakov, Teodor and Trojan, Karel},
title = {Phase Composition of Al–Si Alloys for Internal Combustion Engine Pistons: Finite Element Structural Analysis},
journal = {Metals},
year = {2026},
volume = {16},
number = {3},
pages = {325},
doi = {10.3390/met16030325}
}
EUVIMED