EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Technological Alloying Impact on Formation of Phase Composition of Al-Fe-Si-X Alloys

Violetta Andreyachshenko iD, Lenka Kunčická

Materials · 02.05.2025 · 18 (9) · 2096

DOI: 10.3390/ma18092096 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Materials, online erschienen am 02.05.2025. Verfasst von Violetta Andreyachshenko und 1 weiteren Autor:innen. Beteiligte Einrichtung: Abylkas Saginov Karaganda Technical University, Karaganda 100027, Kazakhstan. Die Arbeit wurde bisher 5-mal zitiert (Crossref) und nennt 71 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Science Committee of the Ministry of Science and Higher Education of the Republic of Kazakhstan.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Given by their low weight and favorable combination of properties, Al-Fe-Si-based intermetallic and duplex alloys are widely used in mechanical engineering. The use of aluminum scrap for their production imparts the necessity for a thorough study of the impacts of presence of impurity/alloying elements on the phase composition. By this reason, individual impacts of the impurity/alloying elements present in the majority of commercial alloys on phase compositions of the alloys were studied herein. Particular emphasis was on the formation of the α phase and features of the α↔β transformation, as well as on their effects on the solidus, liquidus, and phase transformation temperatures. Modeling was used to study the synergistic effect of the simultaneous introduction of 12 elements into aluminum. According to the results, magnesium, copper, and nickel have a tendency to form combined intermetallic phases, and beryllium, as a structurally free element, forms precipitates even at minimum concentrations. Verification of the modelled results was performed using a real alloy prepared experimentally from commercially available raw materials. The comparison of the results provided by computer modeling and the actual phase composition showed sufficient agreement. The herein acquired results contribute to a deeper understanding of the features of phase transitions occurring during alloying of aluminum alloys and will also be useful for predicting microstructures and phase compositions of intermetallic alloys. This research has potential to inspire further development in materials science and engineering.

Schlagwörter

Stichwörter der Autor:innen

AlFeSidiagrams phase transformationintermetallic phasesmicrostructuresimulation and modeling

Autor:innen und Institutionen

  • Abylkas Saginov Karaganda Technical University, Karaganda 100027, Kazakhstan.
  • Department of Metallurgical Technologies, Faculty of Materials Science and Technology, VŠB-Technical University of Ostrava, 17. listopadu 2172/15, 708 00 Ostrava, Czech Republic.
  • Faculty of Mechanical Engineering, Institute of Manufacturing Technology, Brno University of Technology, Technická 2896, 616 00 Brno, Czech Republic.

ORCID-Profile: Violetta Andreyachshenko

Förderung

  • Science Committee of the Ministry of Science and Higher Education of the Republic of Kazakhstan

Zitieren

APA

Andreyachshenko, V., & Kunčická, L. (2025). Technological Alloying Impact on Formation of Phase Composition of Al-Fe-Si-X Alloys. Materials, 18(9), 2096. https://doi.org/10.3390/ma18092096

Vancouver

Andreyachshenko V, Kunčická L. Technological Alloying Impact on Formation of Phase Composition of Al-Fe-Si-X Alloys. Materials. 2025;18(9):2096. doi:10.3390/ma18092096

BibTeX
@article{Andreyachshenko2025,
  author = {Andreyachshenko, Violetta and Kunčická, Lenka},
  title = {Technological Alloying Impact on Formation of Phase Composition of Al-Fe-Si-X Alloys},
  journal = {Materials},
  year = {2025},
  volume = {18},
  number = {9},
  pages = {2096},
  doi = {10.3390/ma18092096}
}
Kostenlos starten →