Enhancement of Surface Finish on FDM-Printed PCL via Robotic Burnishing for Biomedical Applications: An Indirect Measurement Approach
Machines · 08.04.2026 · 14 (4) · 411
DOI: 10.3390/machines14040411 ↗Kurz gefasst
Fachartikel in der Zeitschrift Machines, online erschienen am 08.04.2026. Verfasst von Gabriele Scordamaglia und 5 weiteren Autor:innen. Die Arbeit nennt 46 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Centro Nazionale di Ricerca in High-Performance Computing, Big Data and Quantum Computing, Ageing Well in an Ageing Society.
Abstract (Originalsprache)
The Fused Deposition Modeling (FDM) process often produces parts with high surface roughness, limiting their end-use applications, especially in the biomedical field. This paper presents an experimental study on improving the surface finish of 3D-printed polycaprolactone (PCL) samples using a robotic burnishing process. A key innovation is the development of a low-cost sensorless setup using a 5-DOF manipulator, which controls the applied force by correlating a precise robotic displacement with the known stiffness of springs via Hooke’s law. Ten PCL samples were tested using two burnishing directions: 90° (perpendicular) and 0° (parallel) relative to the printing orientation. The as-printed samples showed a highly anisotropic surface. The 90° trajectory (group 1) proved to be more effective in reducing primary roughness (Ra⊥), lowering the mean Ra from 2.11μm to 1.44μm (a mean reduction of 29.9%). In contrast, the 0° trajectory (group 2) was more effective in reducing roughness Ra‖, lowering its mean Ra from 0.225μm to 0.144μm (a mean reduction of 34.0%). The results demonstrate that the proposed sensorless system is a valid method for surface post-processing of FDM parts when the required forces fall below a specific threshold, ensuring a significant reduction in roughness without damaging the samples. The lower surface roughness obtained with the proposed post-processing strategy may represent a promising approach for improving the surface characteristics of FDM-fabricated polymer scaffolds intended for biomedical applications.
Förderung
- Centro Nazionale di Ricerca in High-Performance Computing, Big Data and Quantum Computing
- Ageing Well in an Ageing Society
Zitieren
APA
Scordamaglia, G., Borgia, C., Perrelli, M., Gagliardi, F., Napoli, L. D., & Mundo, D. (2026). Enhancement of Surface Finish on FDM-Printed PCL via Robotic Burnishing for Biomedical Applications: An Indirect Measurement Approach. Machines, 14(4), 411. https://doi.org/10.3390/machines14040411
Vancouver
Scordamaglia G, Borgia C, Perrelli M, Gagliardi F, Napoli LD, Mundo D. Enhancement of Surface Finish on FDM-Printed PCL via Robotic Burnishing for Biomedical Applications: An Indirect Measurement Approach. Machines. 2026;14(4):411. doi:10.3390/machines14040411
BibTeX
@article{Scordamaglia2026,
author = {Scordamaglia, Gabriele and Borgia, Carmine and Perrelli, Michele and Gagliardi, Francesco and Napoli, Luigi De and Mundo, Domenico},
title = {Enhancement of Surface Finish on FDM-Printed PCL via Robotic Burnishing for Biomedical Applications: An Indirect Measurement Approach},
journal = {Machines},
year = {2026},
volume = {14},
number = {4},
pages = {411},
doi = {10.3390/machines14040411}
}
EUVIMED