Impact of Carbon Nanofiber Fillers on Surface Finish and Dimensional Accuracy in FDM-printed Polymer Composites Parts
Journal of Advanced Manufacturing Systems · 21.05.2026 · 1-14
DOI: 10.1142/s0219686727500661 ↗Kurz gefasst
Fachartikel in der Zeitschrift Journal of Advanced Manufacturing Systems, online erschienen am 21.05.2026. Verfasst von N. Hemanth Kumar und 4 weiteren Autor:innen.
Abstract (Originalsprache)
This paper examines the effect of carbon nanofiber (CNF) reinforcement on the surface finish and dimensional accuracy of the polylactic acid (PLA) composite produced using fused deposition modeling (FDM). Twin-screw compounding was used to prepare PLA-CNF composite filaments with 0–3[Formula: see text]wt.% CNF with extrusion of filaments ([Formula: see text]/[Formula: see text] ratio 30:1, 120[Formula: see text]rpm). To prepare rectangular specimens ([Formula: see text][Formula: see text]mm), the filaments were printed with the nozzle size of 0.4 mm, the layer thickness of 0.1 mm, the infill density of 100%, and the print speed of 5 mm/s. Dimensional accuracy was assessed by a digital vernier caliper with a resolution of ±0.01 mm, and surface roughness (Ra) was measured by a digital surface tester that was stylus-based. Every measurement was averaged three times, and the statistical examination of percent deviation and variance analysis of compositions was done. Findings show that CNF addition was important with respect to the dimensional stability and surface finish. The volume variation of the print decreased to 0.20% of PLA/3 wt.% CNF compared to 0.30% of neat PLA, which is a 33% smaller variation of the dimensional accuracy. The surface roughness also reduced as 0.70 [Formula: see text]m of neat PLA was reduced to 0.42 [Formula: see text]m of PLA/3 wt.% CNF, which is a 40% decrease. It was statistically tested that trends of consistent improvement were observed between compositions. The findings indicate that CNF reinforcement results in a higher level of geometric accuracy and less surface morphology in FDM-printed polymer composites.
Zitieren
APA
Kumar, N. H., Keshavamurthy, R., Adarsha, H., Ram, H. R. A., & Bhandarkar, V. (2026). Impact of Carbon Nanofiber Fillers on Surface Finish and Dimensional Accuracy in FDM-printed Polymer Composites Parts. Journal of Advanced Manufacturing Systems, 1-14. https://doi.org/10.1142/s0219686727500661
Vancouver
Kumar NH, Keshavamurthy R, Adarsha H, Ram HRA, Bhandarkar V. Impact of Carbon Nanofiber Fillers on Surface Finish and Dimensional Accuracy in FDM-printed Polymer Composites Parts. Journal of Advanced Manufacturing Systems. 2026:1-14. doi:10.1142/s0219686727500661
BibTeX
@article{Kumar2026,
author = {Kumar, N. Hemanth and Keshavamurthy, R. and Adarsha, H. and Ram, H. R. Aniruddha and Bhandarkar, Vivek},
title = {Impact of Carbon Nanofiber Fillers on Surface Finish and Dimensional Accuracy in FDM-printed Polymer Composites Parts},
journal = {Journal of Advanced Manufacturing Systems},
year = {2026},
pages = {1--14},
doi = {10.1142/s0219686727500661}
}
EUVIMED