EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Dry-Sliding Behavior and Surface Evolution of SLS-Manufactured Glass Bead-Filled Polyamide 12 Bearings

Ivan Simonović, Dragan Milković, Žarko Mišković, Aleksandar Marinković

Lubricants · 09.01.2026 · 14 (1) · 31

DOI: 10.3390/lubricants14010031 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Lubricants, online erschienen am 09.01.2026. Verfasst von Ivan Simonović und 3 weiteren Autor:innen. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 33 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Ministry of Science, Technological Development and Innovation of the Republic of Serbia.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This study investigates the tribological behavior of selective laser-sintered (SLS) sliding bearings under dry-sliding operating conditions. These polyamide-12 bearings reinforced with glass beads (PA 3200 GF) were tested against a stainless-steel sleeve in three different pressure–velocity (PV) regimes that represent real operating conditions. The coefficient of friction (COF) and contact temperatures were monitored throughout the experiment, while the specific wear rate was quantified based on mass loss measurements. The evolution of surface topography was analyzed using roughness parameters of the Abbott-Firestone family. Scanning electron microscopy (SEM) analysis was performed to identify the dominant wear mechanism. The results show a pronounced running-in phase, after which a stable thermomechanical equilibrium occurs in all regimes. Heavy-loaded regimes increase temperature but accelerate surface adaptation and lower stable coefficients of friction. Lower load regimes have the lowest thermal load but higher friction due to lower real contact. The medium PV regime has a low COF and moderate temperature rise, while peak and core roughness metrics increase more significantly. These results provide an experimentally based insight into the influence of the load regime on the tribological behavior and topography of the SLS-made polymer sliding bearings, thus contributing to a deeper understanding of their operation in real dry-sliding conditions.

Förderung

  • Ministry of Science, Technological Development and Innovation of the Republic of Serbia

Zitieren

APA

Simonović, I., Milković, D., Mišković, Ž., & Marinković, A. (2026). Dry-Sliding Behavior and Surface Evolution of SLS-Manufactured Glass Bead-Filled Polyamide 12 Bearings. Lubricants, 14(1), 31. https://doi.org/10.3390/lubricants14010031

Vancouver

Simonović I, Milković D, Mišković Ž, Marinković A. Dry-Sliding Behavior and Surface Evolution of SLS-Manufactured Glass Bead-Filled Polyamide 12 Bearings. Lubricants. 2026;14(1):31. doi:10.3390/lubricants14010031

BibTeX
@article{Simonovi2026,
  author = {Simonović, Ivan and Milković, Dragan and Mišković, Žarko and Marinković, Aleksandar},
  title = {Dry-Sliding Behavior and Surface Evolution of SLS-Manufactured Glass Bead-Filled Polyamide 12 Bearings},
  journal = {Lubricants},
  year = {2026},
  volume = {14},
  number = {1},
  pages = {31},
  doi = {10.3390/lubricants14010031}
}
Kostenlos starten →