EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Compression Behavior of Material-Extruded Soy Hull Fiber/PLA Biocomposites Across Fiber Content, Raster Architecture, and Filament Manufacturing Phase

Muneeb Tahir, Abdel-Fattah M. Seyam

Journal of Composites Science · 06.11.2026 · 10 (11) · 597

DOI: 10.3390/jcs10110597 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Composites Science, online erschienen am 06.11.2026. Verfasst von Muneeb Tahir und 1 weiteren Autor:innen. Die Arbeit nennt 112 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Previous research on material-extruded soy hull fiber (SHF)/polylactic acid (PLA) has emphasized feedstock development, leaving the joint effects of composition, raster architecture, and filament production history on compression insufficiently characterized. This study addressed that gap through a factorial comparison of 192 coupons spanning four SHF contents (0, 10, 20, and 30 wt.%), four raster sequences, and three filament production positions, without compatibilizers or plasticizers. Build-direction tests measured apparent modulus, 0.2% offset yield stress, and stress at 10% toe-corrected crosshead strain. Literature benchmarking included printed polymers, printed and molded biocomposites, and furniture woods. Relative to neat PLA, 10SHF approximately retained apparent modulus, reduced yield stress by 11.1%, and increased stress at 10% strain by 9.9%; corresponding reductions at 30SHF were 25.0%, 59.9%, and 15.3%. Stress at 10% strain was below offset yield in every 0SHF coupon but above it in every 20SHF and 30SHF coupon. Raster rankings depended on composition and response; some production-position modulus differences exceeded raster contrasts. All twelve 10SHF cell mean yield stresses exceeded six wood benchmarks from one study; apparent modulus means exceeded the compiled printed natural fiber composite values. These findings support partial PLA replacement and further evaluation of short, stocky furniture components under axial compression.

Zitieren

APA

Tahir, M., & Seyam, A. M. (2026). Compression Behavior of Material-Extruded Soy Hull Fiber/PLA Biocomposites Across Fiber Content, Raster Architecture, and Filament Manufacturing Phase. Journal of Composites Science, 10(11), 597. https://doi.org/10.3390/jcs10110597

Vancouver

Tahir M, Seyam AM. Compression Behavior of Material-Extruded Soy Hull Fiber/PLA Biocomposites Across Fiber Content, Raster Architecture, and Filament Manufacturing Phase. Journal of Composites Science. 2026;10(11):597. doi:10.3390/jcs10110597

BibTeX
@article{Tahir2026,
  author = {Tahir, Muneeb and Seyam, Abdel-Fattah M.},
  title = {Compression Behavior of Material-Extruded Soy Hull Fiber/PLA Biocomposites Across Fiber Content, Raster Architecture, and Filament Manufacturing Phase},
  journal = {Journal of Composites Science},
  year = {2026},
  volume = {10},
  number = {11},
  pages = {597},
  doi = {10.3390/jcs10110597}
}
Kostenlos starten →