EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Investigation of Titanium Alloy Cutting Dynamics in Thin-Layer Machining

Anna Zawada-Tomkiewicz, Emilia Zeuschner, Dariusz Tomkiewicz

Applied Sciences · 31.07.2025 · 15 (15) · 8535

DOI: 10.3390/app15158535 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Applied Sciences, online erschienen am 31.07.2025. Verfasst von Anna Zawada-Tomkiewicz und 2 weiteren Autor:innen. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 78 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Koszalin University of Technology.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Manufacturing in modern industrial sectors involves the machining of components where the undeformed chip thickness inevitably decreases to values comparable to the tool edge radius. Under such conditions, the ploughing effect between the workpiece and the tool becomes dominant, followed by the noticeable formation of a stagnation zone. This paper presents research focused on the analysis of the cutting process for small cross-sections of the removed layers, based on cutting force components. This study investigated the machining of two titanium alloy grades—Ti Grade 5 (Ti-6Al-4V) and Ti Grade 2—with the main focus on process stability. A material separation model was analyzed to demonstrate the mechanism of material flow within the cross-section of the machined layer. It was found that the material has a limited ability to flow sideways at the boundary of the chip thickness, thus determining the probable size of the stagnation zone in front of the cutting edge. Orthogonal cutting experiments enabled the determination of the minimum chip thickness coefficient for constant temperature conditions, independent of the tool edge radius, as hmin0= 0.313. In oblique cutting tests, the sensitivity of thin-layer machining was demonstrated for the determined values of minimum undeformed chip thickness. By applying the 0–1 test for chaos, the measurement time (parameter T·dt) was determined for both titanium alloys to determine the range of observable chaotic behavior. The analyses confirmed that Ti Grade 2 enters chaotic dynamics much more rapidly than Ti Grade 5 and displays local cutting instabilities independent of the uncut chip thickness.

Förderung

  • Koszalin University of Technology

Zitieren

APA

Zawada-Tomkiewicz, A., Zeuschner, E., & Tomkiewicz, D. (2025). Investigation of Titanium Alloy Cutting Dynamics in Thin-Layer Machining. Applied Sciences, 15(15), 8535. https://doi.org/10.3390/app15158535

Vancouver

Zawada-Tomkiewicz A, Zeuschner E, Tomkiewicz D. Investigation of Titanium Alloy Cutting Dynamics in Thin-Layer Machining. Applied Sciences. 2025;15(15):8535. doi:10.3390/app15158535

BibTeX
@article{ZawadaTomkiewicz2025,
  author = {Zawada-Tomkiewicz, Anna and Zeuschner, Emilia and Tomkiewicz, Dariusz},
  title = {Investigation of Titanium Alloy Cutting Dynamics in Thin-Layer Machining},
  journal = {Applied Sciences},
  year = {2025},
  volume = {15},
  number = {15},
  pages = {8535},
  doi = {10.3390/app15158535}
}
Kostenlos starten →