EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Portable 3D-printed hand orthosis with spatial stiffness distribution personalized for assisting grasping in daily living

Chan Beom Park, Hyung-Soon Park

Frontiers in Bioengineering and Biotechnology · 02.02.2023 · 11

DOI: 10.3389/fbioe.2023.895745 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Frontiers in Bioengineering and Biotechnology, online erschienen am 02.02.2023. Verfasst von Chan Beom Park und 1 weiteren Autor:innen. Beteiligte Einrichtung: Department of Mechanical Engineering, Korea Advanced Institute of Science and Technology (KAIST), Daejeon, South Korea. Die Arbeit wurde bisher 15-mal zitiert (Crossref) und nennt 54 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Stroke survivors having limited finger coordination require an active hand orthosis to assist them with grasping tasks for daily activities. The orthosis should be portable for constant use; however, portability imposes constraints on the number, size, and weight of the actuators, which increase the difficulty of the design process. Therefore, a tradeoff exists between portability and the assistive force. In this study, a personalized spatial stiffness distribution design is presented for a portable and strengthful hand orthosis. The spatial stiffness distribution of the orthosis was optimized based on measurements of individual hand parameters to satisfy the functional requirements of achieving sufficient grip aperture in the pre-grasping phase and minimal assistive force in the grasping phase. Ten stroke survivors were recruited to evaluate the system. Sufficient grip aperture and high grip strength-to-weight ratio were achieved by the orthosis via a single motor. Moreover, the orthosis significantly restored the range of motion and improved the performance of daily activities. The proposed spatial stiffness distribution can suggest a design solution to make strengthful hand orthoses with reduced weight.

Schlagwörter

Stichwörter der Autor:innen

hand orthosispersonalizedportablespatial stiffness distributionstrengthfulstroke

Autor:innen und Institutionen

  • Department of Mechanical Engineering, Korea Advanced Institute of Science and Technology (KAIST), Daejeon, South Korea.

Zitieren

APA

Park, C. B., & Park, H. S. (2023). Portable 3D-printed hand orthosis with spatial stiffness distribution personalized for assisting grasping in daily living. Frontiers in Bioengineering and Biotechnology, 11. https://doi.org/10.3389/fbioe.2023.895745

Vancouver

Park CB, Park HS. Portable 3D-printed hand orthosis with spatial stiffness distribution personalized for assisting grasping in daily living. Frontiers in Bioengineering and Biotechnology. 2023;11. doi:10.3389/fbioe.2023.895745

BibTeX
@article{Park2023,
  author = {Park, Chan Beom and Park, Hyung-Soon},
  title = {Portable 3D-printed hand orthosis with spatial stiffness distribution personalized for assisting grasping in daily living},
  journal = {Frontiers in Bioengineering and Biotechnology},
  year = {2023},
  volume = {11},
  doi = {10.3389/fbioe.2023.895745}
}
Kostenlos starten →