ANALYSIS OF CUTTING FORCES AND SHEAR ANGLE DURING HOT TURNING OF DIFFICULT-TO-MACHINE MATERIALS TI-6AL-4V AND AISI 316L
Ukrainian Journal of Mechanical Engineering and Materials Science · 2026 · 12 (3) · 10-23
DOI: 10.23939/ujmems2026.03.010 ↗Kurz gefasst
Fachartikel in der Zeitschrift Ukrainian Journal of Mechanical Engineering and Materials Science, 2026. Verfasst von Serhiy Pasternak. Die Arbeit nennt 24 Literaturangaben.
Abstract (Originalsprache)
The article presents the results of experimental and numerical studies on the effect of workpiece preheating on cutting forces and the shear angle during the turning of difficult-to-machine materials-titanium alloy Ti-6Al-4V and austenitic stainless steel AISI 316L. The study aims to establish the regularities of changes in force parameters and the geometry of the primary plastic deformation zone depending on the thermal state of the material. Numerical simulation of the cutting process was performed in the DEFORM-2D software environment using the Johnson-Cook constitutive model. Experimental studies were conducted using a strain-gauge dynamometer and an induction heating system for the workpiece within a temperature range of 20 to 700 °C. It was established that as temperature increases, cutting forces decrease and the shear angle increases for both materials investigated. It is shown that the titanium alloy exhibits a more pronounced reduction in cutting force due to intensive thermal softening, whereas for AISI 316L, this effect is partially compensated by strain hardening. A comparison of the experimental data with the simulation results confirmed the adequacy of the numerical model and the possibility of its application for predicting cutting process parameters in thermally assisted machining.
Zitieren
APA
Pasternak, S. (2026). ANALYSIS OF CUTTING FORCES AND SHEAR ANGLE DURING HOT TURNING OF DIFFICULT-TO-MACHINE MATERIALS TI-6AL-4V AND AISI 316L. Ukrainian Journal of Mechanical Engineering and Materials Science, 12(3), 10-23. https://doi.org/10.23939/ujmems2026.03.010
Vancouver
Pasternak S. ANALYSIS OF CUTTING FORCES AND SHEAR ANGLE DURING HOT TURNING OF DIFFICULT-TO-MACHINE MATERIALS TI-6AL-4V AND AISI 316L. Ukrainian Journal of Mechanical Engineering and Materials Science. 2026;12(3):10-23. doi:10.23939/ujmems2026.03.010
BibTeX
@article{Pasternak2026,
author = {Pasternak, Serhiy},
title = {ANALYSIS OF CUTTING FORCES AND SHEAR ANGLE DURING HOT TURNING OF DIFFICULT-TO-MACHINE MATERIALS TI-6AL-4V AND AISI 316L},
journal = {Ukrainian Journal of Mechanical Engineering and Materials Science},
year = {2026},
volume = {12},
number = {3},
pages = {10--23},
doi = {10.23939/ujmems2026.03.010}
}
EUVIMED