EUVIMEDEUVIMED entdecken
Crossref

Effect of Ceramic Conditioners on Surface Morphology, Roughness, Contact Angle, Adhesion, Microstructure, and Composition of CAD/CAM Ceramics

L T Oliveira, E F de Castro, Vlb Azevedo, O S de Andrade, J J Faraoni, R G Palma-Dibb, Cts Dias, M Giannini

Operative Dentistry · 2023-05 · 48 (3) · 277-293

DOI: 10.2341/21-078-l ↗

Kurz gefasst

Fachartikel in der Zeitschrift Operative Dentistry, 2023-05. Verfasst von L T Oliveira und 7 weiteren Autor:innen. Beteiligte Einrichtung: Letícia Tank Oliveira, DDS, MSc, PhD student, Department of Endodontics, Piracicaba Dental School, University of Campinas, Piracicaba, SP, Brazil. Hauptthemen laut MEDLINE: Dental Porcelain, Dental Bonding. Die Arbeit wurde bisher 11-mal zitiert (Crossref) und nennt 76 Literaturangaben.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The objective of this study was to investigate the effect of surface treatments in maximum profile valley depth (Rv), surface roughness (Sa), contact angle (Ca), shear bond strength (SBS) of a light-cured resin cement, microstructure, and composition of two CAD/CAM ceramics: Cerec Blocs/Dentsply Sirona (feldspathic - FEL) and Empress CAD/Ivoclar Vivadent (leucite-reinforced - LEU). The ceramic specimens were submitted to six surface treatments: (1) 5% hydrofluoric acid (HF) – 20 seconds; (2) 5% HF – 60 seconds; (3) 10% HF – 20 seconds; (4) 10% HF – 60 seconds; (5) self-etching ceramic primer (MEP) – 20 seconds; and (6) MEP – 60 seconds. Specimens treated with HF received silane application for 1 minute. Rv and Sa were evaluated in a confocal laser microscope (n=10) and the Ca in a goniometer (n=6). For the SBS test, two resin cement cylinders were bonded to each specimen, one tested after 24 hours in distilled water storage (37°C) and the other after one year (n=10). The microstructures and compositions were analyzed by scanning electron microscopy (SEM) and energy dispersive x-ray spectroscopy (EDS) (n=4). Rv, Sa, and Ca data were analyzed by two-way ANOVA, and the SBS data by three-way ANOVA, all followed by post-hoc Tukey’s test (α=0.05).

Results

Surface treatments with HF always produced higher Rv and Sa, and lower Ca than MEP 60s for both ceramics. After 1-year water storage, FEL ceramic treated with MEP for 60 seconds produced higher SBS values than HF treatments, whereas for LEU ceramic there were no differences among treatments. Application of MEP for 20 or 60 seconds produced no difference in Rv, Sa, Ca, and SBS for both ceramics. Surface treatments produced considerable differences in ceramic topography, but subtle ones in composition, for both ceramics.

Conclusions

The results indicated that for FEL ceramic, MEP application for 60 seconds yielded higher SBS compared with HF etching, while for LEU ceramic the surface treatments did not influence the SBS results.

Schlagwörter

MeSH-Schlagwörter (MEDLINE)

Dental PorcelainDental BondingResin CementsCeramicsShear StrengthHydrofluoric AcidSurface PropertiesMaterials TestingSilanes

Substanzen

Dental PorcelainResin CementsHydrofluoric AcidSilanes

Autor:innen und Institutionen

  • Letícia Tank Oliveira, DDS, MSc, PhD student, Department of Endodontics, Piracicaba Dental School, University of Campinas, Piracicaba, SP, Brazil.
  • *Eduardo Fernandes de Castro, DDS, MSc, PhD, professor, Department of Prosthodontics, Lenza Institute, Goiânia, GO, Brazil.
  • Veber Luiz Bomfim Azevedo, DDS, MSc, PhD, professor, School of Dentistry of Ilhéus, Ilhéus, BA, Brazil.
  • Oswaldo Scopin de Andrade, DDS, MSc, PhD, professor, National Service for Commercial Education, São Paulo, SP, Brazil.
  • Juliana Jendiroba Faraoni, DDS, MSc, PhD, professor, Department of Restorative Dentistry, Ribeirão Preto School of Dentistry, University of São Paulo, Ribeirão Preto, SP, Brazil.
  • Regina Guenka Palma-Dibb, DDS, MSc, PhD, professor, Department of Restorative Dentistry, Ribeirão Preto School of Dentistry, University of São Paulo, Ribeirão Preto, SP, Brazil.

Zitieren

APA

Oliveira, L. T., de Castro, E. F., Azevedo, V., de Andrade, O. S., Faraoni, J. J., Palma-Dibb, R. G., Dias, C., & Giannini, M. (2023). Effect of Ceramic Conditioners on Surface Morphology, Roughness, Contact Angle, Adhesion, Microstructure, and Composition of CAD/CAM Ceramics. Operative Dentistry, 48(3), 277-293. https://doi.org/10.2341/21-078-l

Vancouver

Oliveira LT, de Castro EF, Azevedo V, de Andrade OS, Faraoni JJ, Palma-Dibb RG, et al. Effect of Ceramic Conditioners on Surface Morphology, Roughness, Contact Angle, Adhesion, Microstructure, and Composition of CAD/CAM Ceramics. Operative Dentistry. 2023;48(3):277-293. doi:10.2341/21-078-l

BibTeX
@article{Oliveira2023,
  author = {Oliveira, L T and de Castro, E F and Azevedo, Vlb and de Andrade, O S and Faraoni, J J and Palma-Dibb, R G and Dias, Cts and Giannini, M},
  title = {Effect of Ceramic Conditioners on Surface Morphology, Roughness, Contact Angle, Adhesion, Microstructure, and Composition of CAD/CAM Ceramics},
  journal = {Operative Dentistry},
  year = {2023},
  volume = {48},
  number = {3},
  pages = {277--293},
  doi = {10.2341/21-078-l}
}
Kostenlos starten →