EUVIMEDEUVIMED entdecken
Open Access · CC BY-NC 3.0

How to obtain the desired results from distal tibial nailing based on anatomy, biomechanics, and reduction techniques

Jungtae Ahn, Se-Lin Jeong, Gu-Hee Jung

Journal of Musculoskeletal Trauma · 2025

DOI: 10.12671/jmt.2025.00024 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Musculoskeletal Trauma, 2025. Verfasst von Jungtae Ahn und 2 weiteren Autor:innen. Die Arbeit wurde bisher 3-mal zitiert (Crossref) und nennt 22 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC 3.0). Gefördert von: Ministry of Science and ICT, Ministry of Trade, Industry and Energy, Ministry of Health and Welfare.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Distal tibial metaphyseal fractures are commonly caused by high-energy injuries in young men and osteoporosis in older women. These fractures should be clearly distinguished from high-energy pilon fractures. Although the optimal surgical intervention methods for distal tibial metaphyseal fractures remain uncertain and challenging, surgical treatments for nonarticular distal tibia fractures can be broadly divided into two types: plate fixation and intramedullary nail (IMN) fixation. Once functional reduction is achieved using an appropriate technique, distal tibial nailing might be slightly superior to plate fixation in reducing postoperative complications. Thus, the surgical strategy should focus on functional realignment and proceed in the following sequence: (1) restoring the original tibial length, regardless of whether fibular fixation is to be done; (2) making the optimal entry point through an anteroposterior (AP) projection based on the overlapping point between the fibular tip and lateral plateau margin; (3) placing Kirschner wires (Ø2.4 mm) as blocking pins (in the AP orientation for coronal control and in the mediolateral [ML] orientation for sagittal control) as close to the upper locking hole as possible without causing further comminution on the concave aspect of the short fragment; and (4) making the the distal fixation construct with at least two ML and one AP interlocking screw or two ML interlocking screws and blocking screws. After the IMN is adequately locked, blocking pins (Ø2.4 mm) need to be replaced by a 3.5 mm screw.

Förderung

  • Ministry of Science and ICT
  • Ministry of Trade, Industry and Energy
  • Ministry of Health and Welfare
  • Ministry of Food and Drug Safety

Zitieren

APA

Ahn, J., Jeong, S., & Jung, G. (2025). How to obtain the desired results from distal tibial nailing based on anatomy, biomechanics, and reduction techniques. Journal of Musculoskeletal Trauma. https://doi.org/10.12671/jmt.2025.00024

Vancouver

Ahn J, Jeong S, Jung G. How to obtain the desired results from distal tibial nailing based on anatomy, biomechanics, and reduction techniques. Journal of Musculoskeletal Trauma. 2025. doi:10.12671/jmt.2025.00024

BibTeX
@article{Ahn2025,
  author = {Ahn, Jungtae and Jeong, Se-Lin and Jung, Gu-Hee},
  title = {How to obtain the desired results from distal tibial nailing based on anatomy, biomechanics, and reduction techniques},
  journal = {Journal of Musculoskeletal Trauma},
  year = {2025},
  doi = {10.12671/jmt.2025.00024}
}
Kostenlos starten →