EUVIMEDEUVIMED entdecken
Crossref

Experimental investigation and optimization of abrasive water jet drilling parameters for CF/PEEK thermoplastic composites

Necdet Yakut, Orhan Çakır

Journal of Reinforced Plastics and Composites · 29.04.2026

DOI: 10.1177/07316844261445665 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Reinforced Plastics and Composites, online erschienen am 29.04.2026. Verfasst von Necdet Yakut und 1 weiteren Autor:innen. Die Arbeit nennt 99 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Abrasive water jet (AWJ) drilling is a thermally benign method enabling damage-tolerant hole production in recyclable carbon fiber-reinforced polyetheretherketone (CF/PEEK) laminates. Using a Taguchi L18 orthogonal array, this study investigated the effects of traverse rate, water-jet pressure, and abrasive mass flow rate on surface roughness (Ra), kerf angle (θ), dimensional deviation (ΔD), and entry/exit delamination factors (Fd). To link process conditions with surface morphology, grey relational analysis (GRA) was integrated with the Taguchi method for multi-response optimization. The analysis revealed that damage mechanisms fundamentally evolve with traverse rate; lower speeds cause interlaminar delamination due to prolonged hydraulic loading, whereas higher speeds shift the damage to localized fiber fracture and erosion. Notably, entry-side delamination was consistently more severe than at the exit. The optimum parameter combination to minimize all defects simultaneously was identified as 1250 mm/min traverse rate, 2000 bar jet pressure, and 350 g/min abrasive mass flow rate. ANOVA confirmed traverse rate as the most dominant factor, contributing approximately 60% to the overall hole quality. Ultimately, this study establishes a robust process window for dimensionally accurate, low-damage AWJ drilling of CF/PEEK composites, highlighting the critical role of traverse speed in governing microscale damage transitions.

Zitieren

APA

Yakut, N., & Çakır, O. (2026). Experimental investigation and optimization of abrasive water jet drilling parameters for CF/PEEK thermoplastic composites. Journal of Reinforced Plastics and Composites. https://doi.org/10.1177/07316844261445665

Vancouver

Yakut N, Çakır O. Experimental investigation and optimization of abrasive water jet drilling parameters for CF/PEEK thermoplastic composites. Journal of Reinforced Plastics and Composites. 2026. doi:10.1177/07316844261445665

BibTeX
@article{Yakut2026,
  author = {Yakut, Necdet and Çakır, Orhan},
  title = {Experimental investigation and optimization of abrasive water jet drilling parameters for CF/PEEK thermoplastic composites},
  journal = {Journal of Reinforced Plastics and Composites},
  year = {2026},
  doi = {10.1177/07316844261445665}
}
Kostenlos starten →