EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

An Investigation of the Limit Cutting Depth of Robotic Milling Based on Response Surface Methodology

Zaiming Geng, Yi Zhang, Mi She, Hui Liu, Jia Zhao, Meiwen Xie, Haohao Zeng

Journal of Engineering · 2026-01 · 2026 (1)

DOI: 10.1155/je/1987883 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Engineering, online erschienen am 20.04.2026. Verfasst von Zaiming Geng und 6 weiteren Autor:innen. Die Arbeit nennt 26 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Robotic milling technology has been gradually applied to the repair of water turbines due to its advantages of high flexibility and low cost. However, the weak rigidity of the serial robot makes the milling process more prone to vibration and chatter. This paper investigates the effects of tool overhang length, spindle inclination angle, and feed rate on the limit cutting depth ( d lim ) and material removal rate (MRR) of robotic milling based on response surface methodology (RSM). Analysis of variance (ANOVA), the three‐dimensional response surface, and the corresponding contour plot are employed to evaluate the impact of factors on d lim and MRR. Two regression models of d lim and MRR are developed based on RSM and then used to optimize the process parameters. The experimental results demonstrate that the combination of parameters optimized by RSM induces a higher chatter‐free MRR and processing efficiency in robotic milling.

Zitieren

APA

Geng, Z., Zhang, Y., She, M., Liu, H., Zhao, J., Xie, M., & Zeng, H. (2026). An Investigation of the Limit Cutting Depth of Robotic Milling Based on Response Surface Methodology. Journal of Engineering, 2026(1). https://doi.org/10.1155/je/1987883

Vancouver

Geng Z, Zhang Y, She M, Liu H, Zhao J, Xie M, et al. An Investigation of the Limit Cutting Depth of Robotic Milling Based on Response Surface Methodology. Journal of Engineering. 2026;2026(1). doi:10.1155/je/1987883

BibTeX
@article{Geng2026,
  author = {Geng, Zaiming and Zhang, Yi and She, Mi and Liu, Hui and Zhao, Jia and Xie, Meiwen and Zeng, Haohao},
  title = {An Investigation of the Limit Cutting Depth of Robotic Milling Based on Response Surface Methodology},
  journal = {Journal of Engineering},
  year = {2026},
  volume = {2026},
  number = {1},
  doi = {10.1155/je/1987883}
}
Kostenlos starten →