Twin‐Screw Extrusion of PHA‐Based Compounds for Injection Molding: Influence of Talc on Thermal Properties and Processability
Advances in Polymer Technology · 2026-01 · 2026 (1)
DOI: 10.1155/adv/3162195 ↗Kurz gefasst
Fachartikel in der Zeitschrift Advances in Polymer Technology, online erschienen am 28.07.2026. Verfasst von Annalisa Genovesi und 1 weiteren Autor:innen. Die Arbeit nennt 66 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
The food packaging sector widely employs injection‐molded items, which are often used only once before disposal. The use of polyhydroxyalkanoates (PHAs) to fabricate these items may represent an effective solution to reduce the amount of plastic waste, but it is currently limited by their high cost, narrow processing window, and poor thermal properties. Three different blends of poly(3‐hydroxybutyrate‐co‐3‐hydroxyhexanoate) (PHBH), amorphous poly(3‐hydroxybutyrate‐co‐4‐hydroxybutyrate) (P3HB4HB), and talc were produced via compounding and injection molding. The inclusion of an amorphous PHA in the blend improves the mechanical properties but leads to a drastic worsening of the processability via injection molding at 30 wt.%. Rheological, mechanical, and thermal characterizations of the blends were performed, along with Fourier transform infrared (FTIR) and XRD analyses. Talc serves as a multifunctional agent, improving compatibility, enhancing rigidity and thermal resistance, and reducing costs. Its primary advantage is the increase in heat deflection temperature (HDT), which can reach up to 95.7°C with the addition of 10 wt.% talc. The elastic modulus of the compound with talc nearly doubles compared to the unfilled version, reaching ~835 MPa. The MFR of the compounds remained in the range 8.8–11 g/10 min after compounding. This study underscores the potential of PHAs as materials for producing injection‐molded single‐use items in the food packaging sector, where biodegradability and high thermal resistance are essential.
Zitieren
APA
Genovesi, A., & Barletta, M. (2026). Twin‐Screw Extrusion of PHA‐Based Compounds for Injection Molding: Influence of Talc on Thermal Properties and Processability. Advances in Polymer Technology, 2026(1). https://doi.org/10.1155/adv/3162195
Vancouver
Genovesi A, Barletta M. Twin‐Screw Extrusion of PHA‐Based Compounds for Injection Molding: Influence of Talc on Thermal Properties and Processability. Advances in Polymer Technology. 2026;2026(1). doi:10.1155/adv/3162195
BibTeX
@article{Genovesi2026,
author = {Genovesi, Annalisa and Barletta, Massimiliano},
title = {Twin‐Screw Extrusion of PHA‐Based Compounds for Injection Molding: Influence of Talc on Thermal Properties and Processability},
journal = {Advances in Polymer Technology},
year = {2026},
volume = {2026},
number = {1},
doi = {10.1155/adv/3162195}
}
EUVIMED