Evaluating Thin-Film Thermocouple Performance on Additively Manufactured Turbine Airfoils
Journal of Turbomachinery · 01.07.2025 · 147 (7)
DOI: 10.1115/1.4067177 ↗Kurz gefasst
Fachartikel in der Zeitschrift Journal of Turbomachinery, online erschienen am 11.12.2024. Verfasst von Reid A. Berdanier und 5 weiteren Autor:innen. Die Arbeit wurde bisher 4-mal zitiert (Crossref) und nennt 47 Literaturangaben. Gefördert von: Advanced Research Projects Agency - Energy.
Abstract (Originalsprache)
As gas turbine engine designs continue to target higher turbine entry temperatures for increased thermal efficiency, gas turbine manufacturers and operators require additional feedback from life-limited engine components. Moreover, additively manufactured (AM) hardware is becoming more prevalent in the engine development cycle to reduce component lead times and associated costs. Although additive manufacturing unlocks unique capabilities for sensor integration, the inherent roughness from additive surfaces poses unique challenges to the direct-write sensor installation processes. The current study addresses these realities by demonstrating sensor operation on additively manufactured vane hardware in a turbine research facility operating at scaled conditions. Thin-film thermocouples were deposited on fully-cooled AM turbine vanes and tested over a range of operating conditions in a one-stage research turbine at Penn State University. The low-profile surface-mounted sensors were compared with traditional small-diameter embedded thermocouples in terms of calibration accuracy and durability. A comparison between traditional masked thermal spray and direct-write installation was also evaluated as part of the sensor integration strategy for the AM vanes. Ultimately, this study shows that thin-film thermocouples on additively manufactured airfoils can operate reliably over an extended test campaign in rig-scaled conditions. Furthermore, the measurement accuracy of thin-film thermocouples demonstrated through this study is equivalent to traditional mineral-insulated thermocouple sensors showing the utility of these technologies for future turbine research and development applications.
Förderung
- Advanced Research Projects Agency - Energy
Zitieren
APA
Berdanier, R. A., Nunn, M. R., Brumberg, J. T., Barringer, M. D., Fishbone, S., & Thole, K. A. (2025). Evaluating Thin-Film Thermocouple Performance on Additively Manufactured Turbine Airfoils. Journal of Turbomachinery, 147(7). https://doi.org/10.1115/1.4067177
Vancouver
Berdanier RA, Nunn MR, Brumberg JT, Barringer MD, Fishbone S, Thole KA. Evaluating Thin-Film Thermocouple Performance on Additively Manufactured Turbine Airfoils. Journal of Turbomachinery. 2025;147(7). doi:10.1115/1.4067177
BibTeX
@article{Berdanier2025,
author = {Berdanier, Reid A. and Nunn, Margaret R. and Brumberg, Justin T. and Barringer, Michael D. and Fishbone, Scott and Thole, Karen A.},
title = {Evaluating Thin-Film Thermocouple Performance on Additively Manufactured Turbine Airfoils},
journal = {Journal of Turbomachinery},
year = {2025},
volume = {147},
number = {7},
doi = {10.1115/1.4067177}
}
EUVIMED