Geometric and Flow Characterization of Additively Manufactured Turbine Blades With Drilled Film Cooling Holes
Journal of Turbomachinery · 01.04.2025 · 147 (4)
DOI: 10.1115/1.4066561 ↗Kurz gefasst
Fachartikel in der Zeitschrift Journal of Turbomachinery, online erschienen am 12.11.2024. Verfasst von Kelsey E. McCormack und 3 weiteren Autor:innen. Die Arbeit wurde bisher 4-mal zitiert (Crossref) und nennt 45 Literaturangaben. Gefördert von: National Aeronautics and Space Administration, U.S. Department of Energy.
Abstract (Originalsprache)
As designers investigate new cooling technologies to advance future gas turbine engines, manufacturing methods that are fast and accurate are needed. Additive manufacturing facilitates the rapid prototyping of parts at a cost lower than conventional casting but is challenged in accurately reproducing small features such as turbulators, pin fins, and film cooling holes. This study explores the potential application of additive manufacturing and advanced hole drill methods as tools to investigate cooling technologies for future turbine blade designs. Data from computed tomography scans are used to nondestructively evaluate each of the cooling features in the blade. The resulting flow performance of these parts is further related to the manufacturing through benchtop flow testing. Results show that while total blade flow is consistent for all additively manufactured cooled blades, flow through smaller regions of the blades shows variations. Shaped film cooling holes manufactured using a high-speed electrical discharge machining method are within tolerance in the metering section but do not expand at the specified angle in the diffuser even though design tolerances are met. In contrast to high-speed EDM, conventional EDM holes are undersized throughout the length of the hole. Due to the additive manufacturing process, the surface roughness was higher on the additively manufactured parts in the current study than has been previously reported for surface roughness of commonly used cast components. The roughness results show high levels on thin walls, particularly at the trailing edge as well as on downskin surfaces. Internal surface roughness is higher than external roughness at most locations on the blade. The results of this study confirm that additive manufacturing along with advanced hole drilling techniques offers faster development of blade cooling designs.
Förderung
- National Aeronautics and Space Administration
- U.S. Department of Energy
Zitieren
APA
McCormack, K. E., Rozman, M., Berdanier, R. A., & Thole, K. A. (2025). Geometric and Flow Characterization of Additively Manufactured Turbine Blades With Drilled Film Cooling Holes. Journal of Turbomachinery, 147(4). https://doi.org/10.1115/1.4066561
Vancouver
McCormack KE, Rozman M, Berdanier RA, Thole KA. Geometric and Flow Characterization of Additively Manufactured Turbine Blades With Drilled Film Cooling Holes. Journal of Turbomachinery. 2025;147(4). doi:10.1115/1.4066561
BibTeX
@article{McCormack2025,
author = {McCormack, Kelsey E. and Rozman, Maria and Berdanier, Reid A. and Thole, Karen A.},
title = {Geometric and Flow Characterization of Additively Manufactured Turbine Blades With Drilled Film Cooling Holes},
journal = {Journal of Turbomachinery},
year = {2025},
volume = {147},
number = {4},
doi = {10.1115/1.4066561}
}
EUVIMED