EUVIMEDEUVIMED entdecken
Open Access · CC BY-NC-ND 4.0

Effect of shot peening on fatigue behavior and microstructure of additively manufactured Co‐Cr‐Mo alloy

Erdogan Polat, Ibrahim Etem Saklakoglu

Fatigue & Fracture of Engineering Materials & Structures · 2024-01 · 47 (1) · 240-253

DOI: 10.1111/ffe.14184 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Fatigue & Fracture of Engineering Materials & Structures, online erschienen am 09.11.2023. Verfasst von Erdogan Polat und 1 weiteren Autor:innen. Die Arbeit wurde bisher 10-mal zitiert (Crossref) und nennt 41 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC-ND 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This investigation delved into the impact of shot peening on the fatigue properties of Co‐Cr‐Mo samples manufactured through laser powder bed fusion. Two primary groups were established, one subjected to stress relief heat treatment. Each group underwent further division, with one subgroup undergoing shot peening. Comprehensive microstructural, fractographic analyses and fatigue tests were conducted. Statistical analysis of fatigue results demonstrated a noteworthy difference ( p < 0.05) between machined and shot‐peened samples across stress levels of 700–70, 600–60, and 500–50 MPa. A statistical significance was observed between machined and heat‐treated, then machined samples within 700–70 and 600–60 MPa stress levels. Fatigue analysis of heat‐treated, then machined samples revealed a shorter life comparing with machined samples at low cycle fatigue (10 5 ). Fracture surface examinations indicated a planar structure with a distinctive quasi‐cleavage texture, affirming that shot peening enhances fatigue behavior by refining mechanical properties.

Zitieren

APA

Polat, E., & Saklakoglu, I. E. (2024). Effect of shot peening on fatigue behavior and microstructure of additively manufactured Co‐Cr‐Mo alloy. Fatigue & Fracture of Engineering Materials & Structures, 47(1), 240-253. https://doi.org/10.1111/ffe.14184

Vancouver

Polat E, Saklakoglu IE. Effect of shot peening on fatigue behavior and microstructure of additively manufactured Co‐Cr‐Mo alloy. Fatigue & Fracture of Engineering Materials & Structures. 2024;47(1):240-253. doi:10.1111/ffe.14184

BibTeX
@article{Polat2024,
  author = {Polat, Erdogan and Saklakoglu, Ibrahim Etem},
  title = {Effect of shot peening on fatigue behavior and microstructure of additively manufactured Co‐Cr‐Mo alloy},
  journal = {Fatigue & Fracture of Engineering Materials & Structures},
  year = {2024},
  volume = {47},
  number = {1},
  pages = {240--253},
  doi = {10.1111/ffe.14184}
}
Kostenlos starten →