EUVIMEDEUVIMED entdecken
VergleichsstudieOpen Access · CC BY 4.0

Fracture load and three‐dimensional internal void analysis of direct composites used to restore worn molars

Topias Yli-Urpo, Jorma Määttä, Auli Suominen, Pekka K Vallittu, Timo Närhi, Anna-Maria Le Bell-Rönnlöf, Jasmina Bijelic-Donova

European Journal of Oral Sciences · 2026

DOI: 10.1111/eos.70104 ↗

Kurz gefasst

Vergleichsstudie in der Zeitschrift European Journal of Oral Sciences, 2026. Verfasst von Topias Yli-Urpo und 6 weiteren Autor:innen. Beteiligte Einrichtung: Institute of Dentistry, University of Turku, Turku, Finland. Hauptthemen laut MEDLINE: Composite Resins, Molar, Tooth Wear, Dental Materials. Die Arbeit nennt 48 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: University of Turku, Turun Yliopisto.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This study evaluated (1) the load‐bearing capacity of molars restored with direct occlusal veneers fabricated either from short‐fiber‐reinforced composite (SFRC) or particulate‐filled composite (PFC) and the presence of internal voids within the materials, and (2) effect of water storage on the fracture load and correlation between internal voids and fracture load. Sixty human molars ( n = 10/group) were prepared with flat occlusal surfaces and preserved enamel margins simulating worn teeth. Conventional molds were taken for each tooth to control the preparation depth and transparent molds to restore the teeth to their original shape. Following bonding procedure, teeth were restored with flowable SFRC, flowable PFC, or condensable PFC using either injectable or pressing technique. Restored teeth were stored in water for 1 d or 6 months before the static loading test. Fracture mode and three‐dimensional internal void analyses were additionally conducted. SFRC occlusal veneers showed significantly higher fracture load (3661 ± 446 N) than both PFC materials, flowable PFC (2064 ± 372 N) and condensable PFC (2183 ± 563 N). SFRC redirected the fractures towards the periphery of the restoration. Prolonged water storage duration or single voids did not adversely affect the fracture load. The use of SFRC as occlusal veneers for restoring molars improves the fracture load and the fracture propagation.

Schlagwörter

MeSH-Schlagwörter (MEDLINE)

Composite ResinsMolarTooth WearDental MaterialsDental Restoration, PermanentTooth FracturesHumansDental VeneersWaterMaterials TestingDental Stress AnalysisTime FactorsSurface PropertiesDental BondingStress, MechanicalResin CementsPolymethacrylic Acids

Stichwörter der Autor:innen

air bubble analysisocclusal veneerparticulate‐filled compositeshort‐fiber‐reinforced compositewater storageworn teeth

Substanzen

Composite ResinsWaterDental MaterialsResin CementsPolymethacrylic Acids

Autor:innen und Institutionen

  • Institute of Dentistry, University of Turku, Turku, Finland.
  • Institute of Biomedicine, Faculty of Medicine, University of Turku, Turku, Finland.
  • Department of Community Dentistry, Institute of Dentistry, University of Turku, Turku, Finland.
  • Department of Biomaterials Science and Turku Clinical Biomaterials Centre, Institute of Dentistry, University of Turku, Turku, Finland.
  • Oral Health Services, Wellbeing Services County of Southwest Finland, Turku, Finland.
  • Department of Prosthetic Dentistry and Stomatognathic Physiology, Institute of Dentistry, University of Turku, Turku, Finland.

Förderung

  • University of Turku
  • Turun Yliopisto

Zitieren

APA

Yli-Urpo, T., Määttä, J., Suominen, A., Vallittu, P. K., Närhi, T., Le Bell-Rönnlöf, A. M., & Bijelic-Donova, J. (2026). Fracture load and three‐dimensional internal void analysis of direct composites used to restore worn molars. European Journal of Oral Sciences. https://doi.org/10.1111/eos.70104

Vancouver

Yli-Urpo T, Määttä J, Suominen A, Vallittu PK, Närhi T, Le Bell-Rönnlöf AM, et al. Fracture load and three‐dimensional internal void analysis of direct composites used to restore worn molars. European Journal of Oral Sciences. 2026. doi:10.1111/eos.70104

BibTeX
@article{YliUrpo2026,
  author = {Yli-Urpo, Topias and Määttä, Jorma and Suominen, Auli and Vallittu, Pekka K and Närhi, Timo and Le Bell-Rönnlöf, Anna-Maria and Bijelic-Donova, Jasmina},
  title = {Fracture load and three‐dimensional internal void analysis of direct composites used to restore worn molars},
  journal = {European Journal of Oral Sciences},
  year = {2026},
  doi = {10.1111/eos.70104}
}
Kostenlos starten →