EUVIMEDEUVIMED entdecken
Crossref

Influence of Using a Puncturing Method and Cooldown Period Before Pressing the Second‐Layered Sheet on the Final Thickness of Double‐Layered Sports Mouthguards: An Experimental Study

Uthai Uma iD, Peerathat Tretanyuth, Puripat Panitchumroen, Sirawish Chomin

Dental Traumatology · 2025

DOI: 10.1111/edt.13007 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Dental Traumatology, 2025. Verfasst von Uthai Uma und 3 weiteren Autor:innen. Beteiligte Einrichtung: Department of Occlusion, Faculty of Dentistry, Chulalongkorn University, Bangkok, Thailand. Hauptthemen laut MEDLINE: Mouth Protectors, Equipment Design, Sports Equipment. Die Arbeit nennt 45 Literaturangaben. Gefördert von: Dental Research Fund 3200502#13/2023..

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Aim

The thickness of the mouthguard is a crucial factor in its protective ability for athletes. This study aimed to investigate the final thickness of double‐layered sports mouthguards, which were fabricated using different methods before pressing the second layer. Materials and Methods Seven upper working models ( n = 7 per group) were prepared for mouthguard fabrication. The first 3‐mm mouthguard sheet underwent heating, pressing, and vacuuming onto the model, followed by various protocols before the second 3‐mm sheet was pressed. Group 1: The second sheet was pressed immediately. Group 2: The first sheet underwent a 1‐h cooldown period before pressing the second sheet. Group 3: The interproximal areas of the first sheet were punctured followed by immediate pressing of the second sheet. Group 4: The first sheet was punctured followed by a 1‐h cooldown before pressing the second sheet. After 24 h, the mouthguard thickness was measured at various points on the left and right central incisors and first molars using a digital caliper. The thickness analysis was performed using SPSS 29.0 with one‐way ANOVA and Tukey post hoc analysis.

Results

At the labial surface of the central incisors, Group 4 exhibited the highest thickness, while Group 3 had the lowest ( p < 0.001). Groups 1 and 2 did not show significant differences in thickness. At the incisal edges, Group 3 again had the lowest thickness ( p < 0.05), with no significant differences observed among the other groups. There were no significant differences in thickness across all areas at the first molars, including cusp tips, pits, and buccal surfaces ( p > 0.05). Group 4 demonstrated greater uniformity at the central incisors in thickness compared with the other groups.

Conclusions

Using the puncturing method at interproximal areas combined with a cooldown period could enhance mouthguard thickness at the labial surfaces of the central incisors and improve its thickness uniformity.

Schlagwörter

MeSH-Schlagwörter (MEDLINE)

Mouth ProtectorsEquipment DesignSports EquipmentHumans

Stichwörter der Autor:innen

cooldown periodmouthguardpuncturing methodsportsthickness

Autor:innen und Institutionen

  • Department of Occlusion, Faculty of Dentistry, Chulalongkorn University, Bangkok, Thailand.
  • Faculty of Dentistry, Chulalongkorn University, Bangkok, Thailand.

ORCID-Profile: Uthai Uma

Förderung

  • Dental Research Fund 3200502#13/2023.

Zitieren

APA

Uma, U., Tretanyuth, P., Panitchumroen, P., & Chomin, S. (2025). Influence of Using a Puncturing Method and Cooldown Period Before Pressing the Second‐Layered Sheet on the Final Thickness of Double‐Layered Sports Mouthguards: An Experimental Study. Dental Traumatology. https://doi.org/10.1111/edt.13007

Vancouver

Uma U, Tretanyuth P, Panitchumroen P, Chomin S. Influence of Using a Puncturing Method and Cooldown Period Before Pressing the Second‐Layered Sheet on the Final Thickness of Double‐Layered Sports Mouthguards: An Experimental Study. Dental Traumatology. 2025. doi:10.1111/edt.13007

BibTeX
@article{Uma2025,
  author = {Uma, Uthai and Tretanyuth, Peerathat and Panitchumroen, Puripat and Chomin, Sirawish},
  title = {Influence of Using a Puncturing Method and Cooldown Period Before Pressing the Second‐Layered Sheet on the Final Thickness of Double‐Layered Sports Mouthguards: An Experimental Study},
  journal = {Dental Traumatology},
  year = {2025},
  doi = {10.1111/edt.13007}
}
Kostenlos starten →