Effects of inlet flow distortion on flow characteristics and flow control performance of an afterburner blown diffuser
Physics of Fluids · 01.11.2026 · 38 (11)
DOI: 10.1063/5.0355948 ↗Kurz gefasst
Fachartikel in der Zeitschrift Physics of Fluids, online erschienen am 09.11.2026. Verfasst von Zhixiang Zhu und 5 weiteren Autor:innen. Die Arbeit nennt 40 Literaturangaben. Gefördert von: National Science and Technology Major Project.
Abstract (Originalsprache)
The diffuser is critical for efficient combustion in aero-engine afterburners, but inlet flow distortion and structural constraints make flow separation more likely. This study experimentally investigates the effects of inlet velocity peak height (h/H = 1/3, 1/2, and 2/3) and blowing flow ratio (0%–4.88%) on the flow characteristics of a blown diffuser based on boundary-layer blowing active control. A blowing momentum coefficient and quantitative scaling laws are introduced to characterize the control sensitivity. The results show that control effectiveness varies with the inlet velocity peak location. When the velocity peak is located at the passage center (h/H = 1/2), blowing effectively suppresses separation with a wide control window. When the velocity peak is close to the blowing-sidewall (h/H = 1/3), separation is suppressed at low blowing ratios. However, flow separation is induced on the opposite wall at moderate blowing ratios. Consequently, the control window is narrowed. When the velocity peak is near the opposite wall (h/H = 2/3), blowing only converts the large-scale separation vortex into a localized reverse flow region. Flow separation cannot be completely eliminated, and increasing the blowing flow ratio further deteriorates the control performance. Overall, the control window is widest at h/H = 1/2, narrow and prone to abrupt upper-wall separation at h/H = 1/3, and persistently limited at h/H = 2/3. Flow pattern evolution and the underlying physical mechanisms are also analyzed. These findings highlight the necessity of considering inlet distortion in blowing system design to avoid control failure or excessive energy consumption.
Förderung
- National Science and Technology Major Project
Zitieren
APA
Zhu, Z., Dong, G., Huang, Y., Tang, K., Zhu, H., & He, X. (2026). Effects of inlet flow distortion on flow characteristics and flow control performance of an afterburner blown diffuser. Physics of Fluids, 38(11). https://doi.org/10.1063/5.0355948
Vancouver
Zhu Z, Dong G, Huang Y, Tang K, Zhu H, He X. Effects of inlet flow distortion on flow characteristics and flow control performance of an afterburner blown diffuser. Physics of Fluids. 2026;38(11). doi:10.1063/5.0355948
BibTeX
@article{Zhu2026,
author = {Zhu, Zhixiang and Dong, Gang and Huang, Yakun and Tang, Kang and Zhu, Huanyu and He, Xiaomin},
title = {Effects of inlet flow distortion on flow characteristics and flow control performance of an afterburner blown diffuser},
journal = {Physics of Fluids},
year = {2026},
volume = {38},
number = {11},
doi = {10.1063/5.0355948}
}
EUVIMED