EUVIMEDEUVIMED entdecken
Crossref

Enhancing diffuser performance using transverse grooves to delay flow separation

Amedeo Cesare Giovanni Bertini, Gianmarco Lunghi, Maurizio Boffadossi, Simone Fenili, Giovanni Lombardi, Marco Maganzi, Alessandro Mariotti

Physics of Fluids · 01.10.2024 · 36 (10)

DOI: 10.1063/5.0231183 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Physics of Fluids, online erschienen am 14.10.2024. Verfasst von Amedeo Cesare Giovanni Bertini und 6 weiteren Autor:innen. Die Arbeit wurde bisher 9-mal zitiert (Crossref) und nennt 54 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

A flow-control method is applied to enhance the efficiency and flow homogeneity of three-dimensional diffusers used in open-jet wind tunnels. Suitably shaped grooves are introduced in the diffuser diverging walls. The grooves promote the relaxation of the non-slip condition along the streamlines bounding the small recirculation regions forming passively inside the grooves. That reduces momentum losses and results in a downstream boundary layer with higher momentum, which is more separation-resistant. The proposed flow-control device has been successfully validated for plane diffusers [Mariotti et al., “Separation control and efficiency improvement in a 2D diffuser by means of contoured cavities,” Eur. J. Mech.-B 41, 138–149 (2013); and Mariotti et al., “Control of the turbulent flow in a plane diffuser through optimized contoured cavities,” Eur. J. Mech.-B 48, 254–265 (2014)]. In this study, we examined circular and square-section diffusers with different degrees of flow separation. Given that the investigated diffusers are part of open-jet wind tunnels, the entire wind tunnel geometry was included in the numerical simulation. The grooves significantly enhanced performance in circular diffusers by reducing the extent of separation and promoting an axisymmetric and spatially uniform flow. However, negligible benefits were observed for square-section diffusers. In these cases, since flow separation originates from one of the four inclined edges of the diffuser, placing grooves along the diverging walls does not effectively reduce the separation extent. Nonetheless, the grooves become effective again in diffusers with rectangular cross sections of high aspect ratio.

Zitieren

APA

Bertini, A. C. G., Lunghi, G., Boffadossi, M., Fenili, S., Lombardi, G., Maganzi, M., & Mariotti, A. (2024). Enhancing diffuser performance using transverse grooves to delay flow separation. Physics of Fluids, 36(10). https://doi.org/10.1063/5.0231183

Vancouver

Bertini ACG, Lunghi G, Boffadossi M, Fenili S, Lombardi G, Maganzi M, et al. Enhancing diffuser performance using transverse grooves to delay flow separation. Physics of Fluids. 2024;36(10). doi:10.1063/5.0231183

BibTeX
@article{Bertini2024,
  author = {Bertini, Amedeo Cesare Giovanni and Lunghi, Gianmarco and Boffadossi, Maurizio and Fenili, Simone and Lombardi, Giovanni and Maganzi, Marco and Mariotti, Alessandro},
  title = {Enhancing diffuser performance using transverse grooves to delay flow separation},
  journal = {Physics of Fluids},
  year = {2024},
  volume = {36},
  number = {10},
  doi = {10.1063/5.0231183}
}
Kostenlos starten →